User manual BOSCH PDA

[. . . ] Book Page 13 Thursday, December 13, 2007 2:21 PM English | 13 General Power Tool Safety Warnings en WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. [. . . ] A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Dust from light alloys can burn or explode. Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Book Page 15 Thursday, December 13, 2007 2:21 PM English | 15 3 Extraction outlet 4 Sanding sheet* 5 Sanding plate 6 SDS button for release of the sanding plate 7 Vacuum hose* 8 Pad extender* 9 Sanding plate for extender* 10 Narrow pad extender* 11 Narrow rounded pad extender* *The accessories illustrated or described are not included as standard delivery. Intended Use The machine is intended for dry sanding and polishing of wood, plastic, metal, filler, as well as for painted surfaces. It is ist especially suitable for profiles, corners or hard to reach locations. Product Features The numbering of the product features refers to the illustration of the machine on the graphics page. 1 On/Off switch 2 Thumbwheel for orbit frequency preselection(PDA 180 E) Technical Data Delta Sander Article number Rated power input Output power No-load speed No-load orbital stroke rate Sanding plate size (corner to corner) Orbit diameter Weight according to EPTA-Procedure 01/2003 Protection class W W rpm opm mm mm kg PDA 180 0 603 339 0. 1 / II The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. noise/Vibration Information Measured values determined according to EN 60745. Typically the A-weighted noise levels of the product are: Sound pressure level 80 dB(A); Sound power level 91 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. Book Page 16 Thursday, December 13, 2007 2:21 PM 16 | English An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. [. . . ] Pay attention to apply uniform sanding pressure; this increases the working life of the sanding sheets. Intensifiying the sanding pressure does not lead to an increase of the sanding capacity, but to increased wear of the machine and the sanding sheet. For precise on-the-spot sanding of edges, corners and hard to reach areas, it is also possible to work only with the tip or an edge of the sanding plate. A sanding sheet that has been used for metal should not be used for other materials. [. . . ]