User manual BOSCH PDA 240 E

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] In accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Penetration of water into the machine increases the risk of an electric shock. Avoid overheating the object being sanded as well as the sander. Always empty the dust collector before taking breaks. , when sparks emit from sanding metals, sanding debris in the dust bag, micro filter or paper sack (or in the filter sack or filter of the vacuum cleaner) can self-ignite. Particularly when mixed with remainders of varnish, polyurethane or other chemical materials and when the sanding debris is hot after long periods of working. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Dust from light alloys can burn or explode. Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Delta Sander Article number Rated power input Output power No-load speed Orbital stroke rate Sanding plate size (corner to corner) Orbit diameter Weight according to EPTA-Procedure 01/2003 Protection class W W rpm PDA 240 E 0 603 346 7. The machine is intended for dry sanding and polishing of wood, plastic, metal, filler, as well as for painted surfaces. It is ist especially suitable for profiles, corners or hard to reach locations. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until Dec. [. . . ] ­ To remove the sanding sheet 5, grasp it at one of the tips and pull it off from the sanding plate 6. Grain size For face sanding and planing small irregularities For finish and fine sanding of hard woods 80, 100, 120 180, 240 40--320 For the working of paint/enamel coats or primers and fillers For sanding off paint For sanding primer For final sanding of primers before coating coarse medium fine 40, 60 80, 100, 120 180, 240, 320 60--400 For working extremely hard materials such as stone, glass, Plexiglas, car paint For pre-sanding For shaping and braking edges For final sanding and forming For polish-sanding and rounding off edges coarse medium fine 60 80, 100, 120 180, 240, 320, 400 Depending on the material to be worked and the required rate of material removal, different sanding sheets are available: Grain size 40--240 For reworking or polishing, especially of metal and stone, use fleece/polishing cloth pad. Depending on the desired surface quality of the workpiece, different fleece types or polishing cloth pads are to be used. Slide the SDS button for release of the sanding plate 4 all the way to the right. [. . . ]