User manual BOSCH PFS 65 REV 2-2008

[. . . ] The laser viewing glasses do not afford complete UV protection and reduce colour perception. Have the measuring tool repaired only through qualified specialists using original spare parts. This ensures that the safety of the measuring tool is maintained. the numbering of the product features shown refers to the illustration of the measuring tool on the graphic page. [. . . ] The trade names of the individual measuring tools may vary. When inserting, pay attention to the correct polarity according to the representation on the inside of the battery lid. Immediately after switching on, the measuring tool sends laser beams out of the exit openings 1. Do not point the laser beam at persons or animals and do not look into the laser beam yourself, not even from a large distance. to switch off the measuring tool , slide the On/Off switch 2 to the "Off" position. When switching off, the levelling unit is locked. Do not leave the switched on measuring tool unattended and switch the measuring tool off after use. Other persons could be blinded by the laser beam. Working with Automatic Levelling (see figure F­G) When working with automatic levelling, the indicator for working without automatic levelling 11 may not be lit. If required, switch the automatic levelling on again by pressing the "Lock" button 7 so that the indicator 11 goes out. Position the measuring tool on a level and firm support, attach it to the holder 12 or to the tripod 17. Always use the centre of the laser line for marking. The width of the laser line changes with the distance. working with the Tripod A tripod 17 offers a stable , height-adjustable measuring support. Place the measuring tool via the tripod mount 3 onto the 1/4" male thread of the tripod 17 or a commercially available camera tripod and screw the locking screw of the tripod tight. adjust the tripod roughly before switching on the measuring tool. Fastening with the Universal Holder (Accessory) (see figures H­K) With the universal holder 12, you can fasten the measuring tool, e. The universal holder is also suitable for use as a ground tripod and makes the height adjustment of the measuring tool easier. Fold the holding plate 14 of the universal holder 12 upward (a) as shown in the figure, so that it engages in this position. Lower the holding plate with adjustment knob 13 to the desired height (b). When using as a wall mount, fasten the universal holder 12 as vertical as possible to a wall with the holding plate folded up. Secure it safely against slipping off, e. [. . . ] In all correspondence and spare parts orders, please always include the 10-digit article number given on the type plate of the measuring tool. Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. Exploded views and information on spare parts can also be found under: www. Com Our customer service representatives can answer your questions concerning possible applications and adjustment of products and accessories. [. . . ]