User manual BOSCH PFZ 700 REV 2-2008

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] damaging a gas line can lead to explosion. Penetrating a water line causes property damage or may cause an electric shock. English | 15 Hold the power tool only by the insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and shock the operator. When working with the machine, always hold it firmly with both hands and provide for a secure stance. The power tool is guided more secure with both hands. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Dust from light alloys can burn or explode. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. 1 Saw blade* 2 Adjustable footplate 3 Slider for SDS saw blade release 4 Thumbwheel for stroke rate preselection 5 On/Off switch 6 Lock-on button for On/Off switch 7 Rotary switch for orbital action All purpose saw Article number Rated power input Output power Stroke rate at no load n0 Tool holder Stroke rate control Orbital action Stroke Cutting capacity, max. ­ in wood ­ in non-alloy steel Weight according to EPTA-Procedure 01/2003 Protection class mm mm mm 28 195 20 W W spm PFZ 700 PE 0 603 362 7. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is intended for sawing wood, plastic, metal and building materials while resting firmly on the workpiece. it is suitable for straight and curved cuts. When using the appropriate bimetal saw blades, it is possible to cut flush to the workpiece surface. The saw blade recommendations must be observed. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. [. . . ] Orbital action switched off (level 0): For working thin or hard material such as sheet metal or steel. Orbital action level I: For working non-ferrous metals, hardwood, plastics or materials of medium density. Before any work on the machine itself, pull the mains plug. For safe and proper working, always keep the machine and ventilation slots clean. [. . . ]