User manual BOSCH PHO 16-82

[. . . ] S Connect machines that are used in the open via a residual current device (RCD) with an actuating current of 30 mA maximum. Use only extension cables that are approved for outdoor use. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. S The planer base plate 11 must lay flat on the surface when working. [. . . ] Use suitable dust /chip extraction and wear a dust respirator. Do not allow fingers to enter the chip ejector 3. When using other vacuum hose systems a suitable extraction adapter may be required. the vacuum cleaner must be suitable for the material to be worked. When vacuuming dry dust that is especially detrimental to health or carcinogenic, use a special vacuum cleaner. Set the required planing depth and place the front part of the planer base plate 11 against the workpiece. Switch the machine on and guide the machine with an even feed over the surface to be planed. To achieve high-grade surfaces, work only with low feed and apply pressure on the centre of the planer base plate. Hardwood) as well as when utilising the maximum planer width, set only low planing depths and reduce planer feed, as required. Excessive feed reduces the surface quality and can lead to rapid clogging of the chip ejector. Only sharp blades achieve good cutting capacity and give the machine longer life. A chip/dust bag 20 (accessory) can be used for smaller jobs. The chip ejector 3 can be switched to the right or left with the selector lever 6. Always press the change lever until it engages in the end position. The V-grooves 12 in the front planer base plate 11 allow quick and easy beveling of workpiece edges. depending on required bevel width , use the corresponding V-groove. For this, place the planer with the V-groove 12 onto the edge of the workpiece and guide along the edge. The blade protector 21 allows the machine to be set down directly after operation, without danger of damaging the working surface or the planer blade. With base unit UG 37), the blade protector must be removed. Press the blade protector together from the sides and pull it off. For non-stationary use, the blade protector must always be assembled. Using the Parallel/Beveling Guide (Accessory ­ see figure D ) Mount parallel guide 13 or beveling guide 17 to the machine using fastening bolt 14 and rebating depth stop 2 using fastening bolt 1. [. . . ] In all correspondence and spare parts orders, please always include the 10-digit order number given on the nameplate of the machine. The wires in the cable are coloured according to the following code: The guide groove of the planer blade always ensures continuous height adjustment when replacing or reversing it. Clean the blade seat (clamping element) and the planer blade respectively, if required. S Rotate the blade drum 22 by hand and ensure that the planer blade does not run into the planer base plate or housing. [. . . ]