User manual BOSCH PLS 300 SET REV 3-2010

[. . . ] Use only extension cables that are approved for outdoor use. S Do not work with materials containing asbestos. Typically the A-weighted noise levels of the product are: sound pressure level: 86 dB (A); sound power level: 99 dB (A). The machine is intended for sawing, filing, brushing and polishing of wood, plastic, metal and building materials while resting firmly against the workpiece. [. . . ] s Apply the machine to the workpiece only when switched on. S When switching on, the saw blades may not lay against, touch or jolt into anything!S When sawing, the base plate 2 must always face against the work piece. S The cutting path must be free of obstacles both above and below. S When working with the machine, always hold it firmly with both hands and provide for a secure stance. S Always switch off the machine and allow to come to a stop before placing it down. S When the cut is completed, switch off the machine and then pull the saw blade out of the cut only after it has come to a standstill (danger of kick-back). Change any cracked, bent or dull saw blades immediately. S Never allow children to use the machine. S Bosch is only able to ensure perfect functioning of the machine if the original accessories intended for it are used. Ake care that the saw blade is held firmly and cannot be pulled out. ­ When the required cutting depth is reached, move machine to a vertical position and continue to saw along the cutting line. ­ Switch machine off and lift off workpiece. For working with soft materials such as light building materials, insulation material, etc. F) Elastic bi-metal saw blades allow to saw off projecting building elements (e. Apply saw blade directly to the wall and bend slightly with some lateral pressure on machine so that base plate 2 rests on the wall. Switch machine on and saw off workpiece with constant lateral pressure. For tight curves, it is best to use a narrow saw balled. Because of the strong heating that occurs when sawing metal, apply a cooling or lubricating agent along the cutting line. For working with soft materials such as soft wood or tree wood. S Check wood, chip boards, building materials etc. for foreign bodies (nails , screws , etc. [. . . ] For safe and proper working, always keep the machine and the ventilation slots clean. To ensure long term flawless operation of the machine, the SDS saw blade holder should be cleaned regularly (PLS 300 SET). This can be done by lightly tapping the machine with the foot plate on a flat surface without a saw blade inserted (see figure G ). If necessary, the SDS saw blade holder should be cleaned by blowing out with compressed air (see figure H ). [. . . ]