User manual BOSCH PLT 2 REV 8-2009

[. . . ] The laser viewing glasses do not afford complete UV protection and reduce colour perception. Have the measuring tool repaired only through qualified specialists using original spare parts. This ensures that the safety of the measuring tool is maintained. Do not allow children to use the laser measuring tool without supervision. [. . . ] Always place the measuring tool level on the floor or fasten it plane against the wall. When placing down or fastening unevenly, the angle will not be precisely 90°. When laying floor tiles, do not use spirit levels 3 and 5 for levelling of the measuring tool. Spirit levels 3 and 5 are used only for alignment against walls. When laying floor tiles, the bubbles of the spirit levels can be within the marks, without the measuring tool being level. Always use the centre of the laser line for marking. The width of the laser line changes with the distance. Never use the laser lines that the measuring tool standing on the floor projects on the wall for alignment. the measuring tool is not self-levelling. Therefore, the line on the wall is distorted. 18 | English The reference point for alignment of tiles is the intersecting point P of the laser lines, directly in front of the measuring tool. To project an angle, the measuring tool must be rotated at this intersecting point, see figure E. Position the measuring tool only on a clean wall holder 13. The measuring tool cannot stand level on an uneven, soiled wall holder surface, which could lead to faulty measuring results. Positioning the Measuring Tool When working on the floor, place down the measuring tool with the bottom plate 10 facing the floor. Place the T-edge 7 of the tool against a wall so that the 0° laser line runs parallel to the reference line (e. Measure the clearance between laser line and reference line directly at the measuring tool and as far away as possible from the measuring tool. Align the measuring tool in such a manner that both clearances are equal. When working on a wall, firstly fasten the wall holder 13 to the wall, e. By placing the wall holder via an opening onto a screw that lightly projects out of the wall. Then tighten the screw to secure the wall holder, see figure D. Fasten the measuring tool with the magnets 8 via the bottom plate 10 against the wall holder 13. [. . . ] Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. Exploded views and information on spare parts can also be found under: www. Com Our customer service representatives can answer your questions concerning possible applications and adjustment of products and accessories. Only for EC countries: Do not dispose of measuring tools into household waste! [. . . ]