User manual BOSCH PMF 10.8 LI REV 5-2010

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Multi-function tool Article number Preselection of orbital stroke rate Rated voltage No-load speed n0 Oscillation angle, left/right Weight according to EPTA-Procedure 01/2003 V= min-1 ° 10. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 2006/42/EC. Measured sound values determined according to EN 60745. Typically the A-weighted noise levels of the product are: Sound pressure level 81 dB(A); Sound power level 92 dB(A). 5 m/s2 Cutting with plunge cut saw blade: Vibration emission value ah =20 m/s2, uncertainty K=2. Only these battery chargers are matched to the lithium ion battery of your power tool. note: The battery is supplied partially charged. To ensure full capacity of the battery, completely charge the battery in the battery charger before using your power tool for the first time. The lithium ion battery can be charged at any time without reducing its service life. interrupting the charging procedure does not damage the battery. The battery is equipped with a NTC temperature control which allows charging only within a temperature range of between 0 °C and 45 °C. A long battery service life is achieved in this manner. Removing the Battery To remove the battery 2, press the unlocking buttons 1 and pull the battery out of the machine to the rear. Indication Continuous lighting, green Continuous lighting, yellow Continuous lighting, red Capacity >70 % 30­70 % <30 % When the battery charge-control indicator 4 flashes red, the machine is subject to overload. Before any work on the machine itself (e. ) as well as during transport and storage, remove the battery from the power tool. There is danger of injury when unintentionally actuating the On/Off switch. [. . . ] For safe and proper working, always keep the machine and ventilation slots clean. Clean Riff application tools (accessory) regularly with a wire brush. If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an after-sales service centre for Bosch power tools. In all correspondence and spare parts order, please always include the 10-digit article number given on the type plate of the machine. [. . . ]