User manual BOSCH PMF 180 E MULTI

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. damaged cables increase the risk of an electric shock. Wear protective gloves when changing application tools/accessories. Application tools/accessories become hot after prolonged usage. Penetration of water into the machine increases the risk of an electric shock. English | 15 Do not treat the surface to be worked with solvent-containing fluids. Materials being warmed up by the scraping can cause toxic vapours to develop. Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. the replacement plug should have the same fuse rating as the original plug. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a mains socket elsewhere. Products sold in AUS and NZ only: Use a residual current device (RCD) with a rated residual current of 30 mA or less. 6 Venting slots 7 Tool holder 8 Plunge saw blade 9 10 11 12 13 Clamping bolt with washer Allen key Sanding plate Sanding sheet Segment saw blade A complete overview of accessories can be found in our accessories program. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Multi-function tool Article number Preselection of orbital stroke rate Rated power input Output power No-load speed n0 Oscillation angle, left/right Weight according to EPTA-Procedure 01/2003 Protection class W W 180 74 PMF 180 E 3 603 A00 0. It is also suitable for working soft wall tiles, as well as for dry sanding and scraping of small surfaces. It is especially suitable for working close to edges and for flush cutting. Operate the power tool exclusively with Bosch accessories. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. [. . . ] Plunge cuts may only be applied to soft materials, such as wood, gypsum plaster boards, etc. Before sawing with HCS saw blades in wood, particle board, building materials, etc. , check these for foreign objects such as nails, screws, or similar. If required, remove foreign objects or use BIM saw blades. [. . . ]