User manual BOSCH PML LI REV 8-2010

[. . . ] Do not cover off the lamp head while operating the cordless worklight. The lamp head heats up during operation and can cause burns when the heat accumulates. Do not use the cordless worklight in road traffic. The cordless worklight is not approved for illumination in road traffic. [. . . ] Position the battery adapter in such a manner that you can operate the On/Off switch 11 behind the symbol on the pouch. The connection cable 3 can be conducted through the slot in the pouch. The protective pouch 9 can be fastened to your belt by the loop on its backside or to any object with a Velcro strap. Inserting the Battery Use only original Bosch lithium ion batteries with the voltage listed on the nameplate of your cordless worklight. Using other batteries can lead to injuries and pose a fire hazard. insert a charged battery 14 into the battery adapter 12. Take care to insert the battery in the right position, and that the battery unlocking button 15 can be felt to engage in the battery adapter 12. Removing the Battery To remove the battery 14, press the battery unlocking button 15 and pull the battery toward the rear out of the cordless worklight. With the flexible neck 2, you can convert the cordless worklight to a stand-lamp. ­ Guide the base of the flexible neck alongside the guide grooves in the seat of the battery adapter 12 until it engages. ­ Insert lamp head 1 into the flexible neck 2 until it engages. ­ Insert the plug of the cable from the flexible neck 2 into the socket of the lamp head 1. Mount components to the worklight only when the battery 14 is not inserted. Note: When inserting a completely mounted cordless worklight with the battery into the battery charger, the cordless worklight is automatically deactivated. To remove the lamp head 1, pull out the cable, lightly press release lever 16 upward and pull the lamp head toward the rear off of the component. For optimal alignment of the light beam, the pipe clamp can be swivelled up to 12. Lens Plate (see figure J) The lens plate 13 is used to scatter or diffuse the light when using the cordless worklight e. When the battery is no longer operative, please refer to an authorised after-sales service agent for Bosch power tools. the cordless worklight is maintenance-free and and contains no components that must be replaced or maintained. To avoid damage, clean the plastic lens of the cordless worklight only with a dry, soft cloth. [. . . ] dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and pack up the battery in such a manner that it cannot move around in the packaging. When dispatching lithium-ion batteries, compulsory labeling may be required. Do not dispose of cordless worklights into household waste! [. . . ]