User manual BOSCH POF 1200 AE REV 8-2009

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. Typically the A-weighted noise levels of the product are: Sound pressure level 95 dB(A); Sound power level 106 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. English | 23 An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Router bits made of high speed steel (HSS) are suitable for the machining of soft materials, e. Original router bits from the extensive Bosch accessories program are available at your specialist shop. Only use clean router bits that are in perfect condition. ­ Push the spindle lock button 3 and keep it pressed. if required , rotate the motor spindle by hand until it locks. ­ Loosen the tightening nut 25 with the openend spanner 26 (size 19 mm) by turning in rotation direction . Insert the router bit into the collet. The shank of the router bit must be immersed at least 20 mm into the collet. ­ Tighten the tightening nut 25 with the openend spanner 26 (size 19 mm) by turning in rotation direction . Do not insert a router bit with a diameter larger than 50 mm when the guide bushing is not mounted. Such router bits do not fit through the base plate. [. . . ] Select a router bit with a diameter smaller than the interior diameter of the guide bushing. For routing with the guide bushing 43 proceed as follows: ­ Guide the switched on power tool with the guide bushing toward the template. ­ Push clamping lever 16 down and slowly lower the plunge router until the adjusted depthof-cut is reached. Let go of the clamping lever 16 again to lock this plunge depth. [. . . ]