User manual BOSCH POWER4ALL PSM18LI

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mainsoperated (corded) power tool or battery-operated (cordless) power tool. Book Page 12 Monday, June 17, 2013 11:30 AM 12 | English Work area safety  Keep work area clean and well lit. [. . . ] ς„ In case of damage and improper use of the battery, vapours may be emitted. Ventilate the area and seek medical help in case of complaints. The vapours can irritate the respiratory system. ς„ Use the battery only in conjunction with your Bosch power tool. This measure alone protects the battery against dangerous overload. ς„ Use only original Bosch batteries with the voltage listed on the nameplate of your power tool. Imitations, reconditioned batteries or other brands, there is danger of injury as well as property damage through exploding batteries. *Accessories shown or described are not part of the standard delivery scope of the product. A complete overview of accessories can be found in our accessories program. Technical Data Cordless Multi Sander Article number Rated voltage No-load speed No-load orbital stroke rate Sanding sheet surface Orbit diameter Weight according to EPTA-Procedure 01/2003 PSM 18 LI 3 603 CA1 3. 3 V= min-1 min-1 cm2 mm kg Noise/Vibration Information Measured sound values determined according to EN 60745. Typically the A-weighted sound pressure level of the product is 72 dB(A). The noise level when working can exceed 80 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Intended Use The machine is intended for dry sanding and polishing of wood, filler and coated surfaces. [. . . ] Protection Against Deep Discharging The Lithium-Ion battery is protected against deep discharging by the “Electronic Cell Protection (ECP)”. When the battery is empty, the machine is switched off by means of a protective circuit: The inserted tool no longer rotates. Specialty Sanding Plates You can replace the supplied sanding plate 5 with a specialty sanding plate, which is available as an accessory. The specialty sanding plate is attached in the same manner as the one supplied. [. . . ]