User manual BOSCH POWER4ALL PST18LI

[. . . ] Work area safety  Keep work area clean and well lit. cluttered or dark areas invite accidents. ς Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. [. . . ] an unclean shank cannot be fastened securely. If required, remove the dust cover 11 (see “Dust Cover”). Push the saw blade holder 17 upward in the direction of the arrow. Insert the saw blade 14 (teeth in cutting direction) to the stop into the saw blade holder. The splinter guard can only be used for certain saw blade types and only for cutting angles of 0°. When sawing with the splinter guard, the base plate 9 must not be moved back for cuts that are close to the edge. Press the splinter guard 20 from below into the base plate 9 (with the notch facing upward as shown in the figure). €Cut Control” “Cut Control” enables precise guiding of the power tool along a cutting line marked on the workpiece. The “Cut Control” kit includes the viewing window 15 with cutting marks and the base 13 for attachment to the power tool. Attaching “Cut Control” to the Base Plate (see figure F) Clamp the “Cut Control” 15 viewing window into the holders of the base 13. Then, lightly press the base together and allow it to engage into the lead 21 of the base plate 9. Replacing/Inserting the Saw Blade  When mounting the saw blade, wear protective gloves. Danger of injury when touching the saw blade. Dust/Chip Extraction  Dusts from materials such as lead-containing coatings, some wood types, minerals and metal can be harmful to one’s health. Touching or breathing-in the dusts can cause allergic reactions and/or lead to respiratory infections of the user or bystanders. Book Page 18 Monday, February 23, 2015 2:26 PM 18 | English Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with wood-treatment additives (chromate, wood preservative). Materials containing asbestos may only be worked by specialists. € As far as possible, use a dust extraction system suitable for the material. € Provide for good ventilation of the working place. – It is recommended to wear a P2 filter-class respirator. Observe the relevant regulations in your country for the materials to be worked. Dust Cover (see figures G – H) Mount the dust cover 11 before connecting the machine to the dust extraction. [. . . ] : air transport or forwarding agency), special requirements on packaging and labelling must be observed. For preparation of the item being shipped, consulting an expert for hazardous material is required. Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and pack up the battery in such a manner that it cannot move around in the packaging. [. . . ]