User manual BOSCH PRIO LITHIUM-ION REV 8-2009

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] In case of damage and improper use of the battery, vapours may be emitted. Provide for fresh air and seek medical help in case of complaints. the vapours can irritate the respiratory system. When the battery is defective, liquid can escape and come into contact with adjacent components. Clean such parts or replace them, if required. Do not operate the battery charger on easily inflammable surfaces (e. The heating of the battery charger during the charging process can pose a fire hazard. Children should be supervised to ensure that they do not play with the battery charger. Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. the replacement plug should have the same fuse rating as the original plug. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a mains socket elsewhere. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Keep the battery charger away from rain or moisture. penetration of water in the battery charger increases the risk of an electric shock. The battery charger is suitable only for charging Bosch lithium ion batteries within the listed voltage range. Before each use, check the battery charger, cable and plug. Have repairs performed only by a qualified technician and only using original spare parts. The machine is intended for dry sanding and polishing of wood, filler and coated surfaces. It is especially suitable for profiles, corners or hard to reach locations. Use the battery charger only when you fully understand and can perform all functions without limitation, or have received appropriate instructions. [. . . ] Pay attention to apply uniform sanding pressure; this increases the working life of the sanding sheets. Intensifiying the sanding pressure does not lead to an increase of the sanding capacity, but to increased wear of the machine and the sanding sheet. For precise on-the-spot sanding of edges, corners and hard to reach areas, it is also possible to work only with the tip or an edge of the sanding plate. A sanding sheet that has been used for metal should not be used for other materials. [. . . ]