User manual BOSCH PSB 24 VE-2

[. . . ] Otherwise danger of injury is given when unintentionally actuating the On /Off switch. s Convince yourself before using that the battery is securely seated in the machine. S Do not strain the machine so heavily that it comes to a standstill. s PSB 18 VE-2/PSB 24 VE-2: Operate the machine only with the auxiliary handle 4. [. . . ] A long battery service life is achieved in this manner. A significantly reduced working period after charging indicates that the batteries are used and must be replaced. Screw the auxiliary handle 4 on the right or left of the machine head depending on the working method. Open the drill chuck 3 by turning until the tool can be inserted. Firmly tighten the sleeve of the keyless chuck 3 by hand until the locking action ("click") is no longer heard. Two speed ranges can be preselected with the gear selector 1: 1st gear: Low rotational speed, high power. 2nd gear: High rotational speed, less power. The speed settings may only be changed when the machine is motionless. If the speed setting has not quite notched in properly, briefly press the On/Off switch 9. Directly clamp the screwdriver bit 7 into the drill chuck or use the additional universal bit holder 12 when operating with hex shank bits 11. The drill spindle is locked when the On /Off switch 9 is not pressed. This makes quick and easy changing of the tool in the drill chuck possible. The locked drill chuck enables retightening of projecting screws by using the switched-off machine as a screwdriver. Set the rotational direction switch 8 to the centre position = lock-off and allow the charged battery 5 to engage into the handle. The machine runs with variable speed between 0 and maximum, depending on the pressure applied to the On/Off switch 9. Light pressure results in a low rotational speed thus allowing smooth, controlled starts. Do not strain the machine so heavily that it comes to a standstill. To switch off the machine, release the On/Off switch 9. However, this is not possible with the On/Off switch 9 actuated. When releasing the On/Off switch 9 the speed of the drill chuck is reduced to a stop, thus preventing the run-on of the tool. For screwdriving applications, wait until the screw is flush with the material and then release the On/ Off switch 9. The screw head does not penetrate into the material then. [. . . ] Hold the machine firmly and loosen the chuck by turning to the left, as when unscrewing a screw (). Loosen a tight chuck by giving the long end of the Allen key 13 a sharp blow. Recycle raw materials instead of disposing as waste The machine, accessories and packaging should be sorted for environmental-friendly recycling. These instructions are printed on recycled paper manufactured without chlorine. [. . . ]