User manual BOSCH PSB 700-2 RE

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] Vibration total values (triax vector sum) determined according to EN 60745: Drilling into metal: Vibration emission value ah =3. WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to a significant underestimate of exposure when the tool is used regularly in such a way. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 89/336/EEC, 98/37/EC (until Dec. Impact Drill Article number Rated power input Output power No-load speed ­ 1st gear ­ 2nd gear Impact rate Rated torque (1st/2nd gear/position "S") Torque at max. Chuck clamping range Weight according to EPTA-Procedure 01/2003 Protection class PSB 700-2 RE PSB 780-2 RE PSB 800-2 RA PSB 1000-2 RCA PSB 1000-2 RCE 3 603 A72 5. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. Use the dust/chip extraction only when working concrete, brick and brickwork. Wood or plastic chips can easily lead to clogging. Do not work metallic materials with the extraction device mounted. Hot metal chips can ignite parts of the extraction device. Pay attention that the extraction device faces flush against the workpiece or the wall. This also makes drilling at a right angle easier. When using the extraction device, always work with the maximum speed. After reaching the desired drilling depth, pull the drill bit out of the drill hole first and then switch off the impact drill. The dust protection ring 17 can wear, especially when working with large drill-bit diameters. Adjusting the Drilling Depth (see figure C) With the extraction device mounted, the drilling depth "X" can be adjusted. [. . . ] The overload protection indicator 6 lights up continuously when the gear selector 11 is in the "S" position. the overload protection is deactivated when the gear selector 11 is in the "S" position. Be prepared for high reaction torque when the drilling tool jams. After longer periods of working at low speed, allow the machine to cool down by running it for approx. [. . . ]