User manual BOSCH PSB 700 RE

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] Switch off the power tool immediately when the tool insert jams. Be prepared for high reaction torque that can cause kickback. The tool insert jams when: -- the power tool is subject to overload or -- it becomes wedged in the workpiece. Hold the power tool only by the insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and shock the operator. When working with the machine, always hold it firmly with both hands and provide for a secure stance. The power tool is guided more secure with both hands. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Dust from light alloys can burn or explode. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. 1 Keyless chuck 2 Spindle lock button 3 "Drilling/Impact Drilling" selector switch 4 Lock-on button for On/Off switch 5 On/Off switch 6 Thumbwheel for speed preselection 7 Rotational direction switch 8 Button for depth stop adjustment 9 Wing bolt for adjustment of auxiliary handle 10 Auxiliary handle* 11 Depth stop* 12 Chuck key* 13 Key chuck* 14 Allen key** The machine is intended for impact drilling in brick, concrete and stone as well as for drilling in wood, metal and plastic. Machines with electronic control and right/left rotation are also suitable for screwdriving and thread-cutting. Impact Drill Article number Rated power input Output power No-load speed Impact rate Rated torque Spindle lock Spindle collar dia. ­ Concrete ­ Steel ­ Wood Chuck clamping range Weight according to EPTA-Procedure 01/2003 Protection class mm mm mm mm mm kg 43 16 12 30 1. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. [. . . ] Use dust extraction whenever possible. ­ Provide for good ventilation of the working place. The voltage of the power source must agree with the voltage specified on the nameplate of the machine. Power tools marked with 230 V can also be operated with 220 V. [. . . ]