User manual BOSCH PSB14.4LI

[. . . ] Book Page 15 Friday, December 5, 2008 9:09 AM English | 15 Safety Notes en General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. [. . . ] 45 Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. noise/Vibration Information Measured values determined according to EN 60745. Typically the A-weighted sound pressure level of the product is 70 dB(A). The noise level when working can exceed 80 dB(A). Vibration total values (triax vector sum) determined according to EN 60745: Drilling into metal: Vibration emission value ah =2. The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Declaration of Conformity We declare under our sole responsibility that the product described under “Technical Data” is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until 28 Dec 2009), 2006/42/EC (from 29 Dec 2009). Eckerhard Strötgen Head of Product Certification The battery is equipped with a NTC temperature control which allows charging only within a temperature range of between 0 °C and 45 °C. A long battery service life is achieved in this manner. 2008 Changing the Tool (see figure B) Before any work on the machine (e. Unintentional actuation of the On/Off switch can lead to injuries. The drill spindle is locked when the On/Off switch 11 is not pressed. This makes quick, convenient and easy changing of the tool in the drill chuck possible. Open the keyless chuck 2 by turning in rotation direction , until the tool can be inserted. [. . . ] The lithium-equivalent content in the battery is below applicable limit values. Therefore, the battery is not subject to national or international regulations pertaining to dangerous mediums, neither as an individual component nor when inserted into a machine. However, the regulations governing dangerous goods may be relevant when transporting several batteries. In this case, it can be necessary to comply with special conditions (e. [. . . ]