User manual BOSCH PSR 1200

[. . . ] Working safely with this machine is possible only when the operating and safety information are read completely and the instructions contained therein are strictly followed. In addition, the general safety notes in the enclosed booklet must be observed. Before each use, check the machine and battery. The rated voltage of the battery must agree with the data on the machine. [. . . ] S The enclosed operating instructions for the battery charger must be read carefully!S The battery and battery charger are designed to match each other. When charging the battery, use only a Bosch battery charger designed for it with a charging voltage that corresponds with the battery (see type plate). Do not place the battery on radiators or expose to strong sun rays for a longer time; temperatures over 50 °C cause damage. S Do not open the battery, and protect it from impact. S Do not throw the battery into the household waste, into fire or water. Directly clamp the screwdriver bit into the drill chuck or use the additional universal bit holder 8 when operating with hex shank bits 7. Set the rotational direction switch 3 to the centre position = lock-off and allow the charged battery 5 to engage into the handle. The machine runs with variable speed between 0 and maximum, depending on the pressure applied to the On/Off switch 4. Light pressure results in a low rotational speed thus allowing smooth, controlled starts. Do not strain the machine so heavily that it comes to a standstill. To switch off the machine, release the On/Off switch 4. Before Putting into Operation Battery Charging A battery that is new or has not been used for a longer period does not develop its full capacity until after approximately 5 charging/discharging cycles. to remove the battery 5 , press the unlocking buttons 6 and pull out the battery downwards. The battery is equipped with an NTC temperature control which allows charging only within a temperature range of between 0 °C and 45 °C. A long battery service life is achieved in this manner. A significantly reduced working period after charging indicates that the batteries are used and must be replaced. However, this is not possible with the On /Off switch 4 actuated. For machines without a drill spindle locking facility, the chuck must be changed by an authorised after-sales service shop for Bosch power tools. The chuck must be tightened with a torque of approx. [. . . ] the plastic components are labelled for categorized recycling. Nickel-cadmium-battery: If your product is equipped with a nickel-cadmium-battery, the battery must be collected, recycled or disposed of in an environmentally-friendly way. Defective or worn out batteries must be recycled according to the guidelines 91/157/EEC. Batteries no longer suitable for use can be directly returned at: Great Britain Robert Bosch Ltd. [. . . ]