User manual BOSCH PST7200E

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mainsoperated (corded) power tool or battery-operated (cordless) power tool. WARNING Work area safety  Keep work area clean and well lit. [. . . ] Bosch Power Tools Power tool use and care  Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. Book Page 9 Monday, November 3, 2014 11:55 AM English | 9  Use only undamaged saw blades that are in perfect condition. Bent or dull saw blades can break, negatively influence the cut, or lead to kickback. ς Do not brake the saw blade to a stop by applying side pressure after switching off. The saw blade can be damaged, break or cause kickback. ς Use suitable detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. Contact with electric lines can lead to fire and electric shock. damaging a gas line can lead to explosion. Penetrating a water line causes property damage or may cause an electric shock. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. ς Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. ς To save energy, only switch the power tool on when using it. ς Before any work on the machine itself, pull the mains plug. ς Clean the shank of the saw blade before inserting it. an unclean shank cannot be fastened securely. ς Check the tight seating of the saw blade. A loose saw blade can fall out and lead to injuries. ς The saw blade should not be longer than required for the intended cut. Use a narrow saw blade when sawing tight curves. [. . . ] The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary. high stroke rate When sawing metal , apply coolant/ lubricant alongside the cutting line. Article number (10-digit) Declaration of Conformity We declare under our sole responsibility that the product described under “Technical Data” is in conformity with all relevant provisions of the directives 2011/65/EU, 2014/30/EU, 2006/42/EC including their amendments and complies with the following standards: EN 60745-1, EN 60745-2-11. [. . . ]