User manual BOSCH PST9500PEL

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mainsoperated (corded) power tool or battery-operated (cordless) power tool. WARNING Work area safety  Keep work area clean and well lit. [. . . ] An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. Switch the saw dust blower off when a dust extraction system is connected (see “Sawdust Blower Device”). The vacuum cleaner must be suitable for the material being worked. When vacuuming dry dust that is especially detrimental to health or carcinogenic, use a special vacuum cleaner. €Cut Control” “Cut Control” enables precise guiding of the power tool along a cutting line marked on the workpiece. The “Cut Control” kit includes the viewing window 12 with cutting marks and the base 13 for attachment to the power tool. Attaching “Cut Control” to the Base Plate (see figure D) Clamp the “Cut Control” 12 viewing window into the holders of the base 13. Then, lightly press the base together and allow it to engage into the lead 23 of the base plate 7. Attaching “Cut Control” to the Sliding Shoe (PST 1000 PEL) (see figure E) With this cutting-line control system, the “Cut Control” viewing window 12 can either be fastened together with the base 13 to the base plate 7 or separate, directly in the holder of the sliding shoe 11. Remove the “Cut Control” base 13 from base plate 7. For this, lightly press the base together and remove it from the guide 23. Pull off the “Cut Control” viewing window 12 from base 13 and clamp it into the holders on the sliding shoe 11. Operation Operating Modes  Before any work on the machine itself, pull the mains plug. Orbital Action Settings The four orbital action settings allow for optimal adaptation of cutting speed, cutting capacity and cutting pattern to the material being sawed. The orbital action can be adjusted with the adjusting lever 8, even during operation. No orbital action Small orbital action Medium orbital action Large orbital action The optimal orbital action setting for the respective application can be determined through practical testing. The following recommendations apply: – Select a lower orbital action setting (or switch it off) for a finer and cleaner cutting edge. € For soft materials and when sawing in the direction of the grain, work with maximum orbital action. Adjusting the Cutting Angle The base plate 7 can be swivelled by 45° to the left or right for mitre cuts. The dust cover 10 and the splinter guard 22 cannot be used when performing mitre cuts. If required, remove the dust cover 10 (see “Dust Cover”, page 17) and take off the splinter guard 22 (see “Splinter Guard”, page 17). PST 900 PEL/PST 9500 PEL (see figure G): – Pull the saw blade storage 21 out of the base plate 7. [. . . ] Lubricate the guide roller 18 occasionally with a drop of oil. If worn, it must be replaced through an authorised Bosch after-sales service agent. If the replacement of the supply cord is necessary, this has to be done by Bosch or an authorized Bosch service agent in order to avoid a safety hazard. Book Page 20 Thursday, November 13, 2014 4:38 PM 20 | Français After-sales Service and Application Service Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. [. . . ]