User manual BOSCH PTK 14 E

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] g) Use the power tool , accessories and tool bits etc. In accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is not suitable for the attachment of wall and ceiling panelling. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Trigger Thumbwheel for hammer-force preselection Magazine slider Latching aperture for support foot Latching aperture for spacer clamp Latching aperture for stapler plate Tacker head Duotac automatic selector switch Nail strip* Staple strip* Magazine Support foot* Stapler plate* Spacer clamp* A workpiece clamped with clamping devices or in a vice is held more secure than by hand. B Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. B Keep your fingers away from the tacker head 7. There is danger of injury when unintentionally actuating the On/Off switch. b Never point the machine at persons or animals. Staples or nails shot from a short distance can cause considerable injuries. b Do not use the machine to fasten electrical wiring. Contact with electric lines can lead to fire and electric shock. Weight according to EPTA-Procedure 01/2003 Protection class PTK 14 E 0 603 265 2. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. The noise level when working can exceed 85 dB(A). [. . . ] Therefore, allow the machine to cool off after 15 minutes (maximum) of continuous operation. Stapler Plate (see figure B) With the stapler plate 13, materials with a thickness of up to 8 mm, such as notepads, seminary paperwork, thin-walled pressboard or fabrics, can be stapled. Depending on the click-on position of the stapler plate 13, the stapler tips are bent toward the inside or outside. The data in the following table are recommended values. [. . . ]