User manual BOSCH PTL 1

[. . . ] Connect machines that are used in the open via a residual current device (RCD) with an actuating current of 30 mA maximum. Do not operate the machine in rain or moisture. Before each use of the machine, check the cable and plug. If the cable is damaged or cut through while working, do not touch the cable but immediately pull the mains plug. [. . . ] Never open the tank and the bayonet connections during operation. Never mix combustible, poisonous, caustic or other liquids (e. Filling with Water Only then open the tank: ­ Turn the tank cap lightly counter clockwise to the first stop (position 2. ­ Allow steam to escape until no more steam is emitted. Fill with water to the maximum marking on the water level indicator 2. If the unit is filled with warm water, the heating time is shortened. Close the tank securely after filling: Place on the tank cap (position 3. ) , press down and tighten clockwise to the stop. A correctly close tank cap is shown in the following illustration position 1. When filling, take care that the grid over the rubber surge protector 3 is not pressed in by the filling container. Refilling with Water Take care when loosening the tank cap. When working for longer periods: Pay attention to the minimum marking on the water level indicator 2 and refill with water in time. The voltage of the power source must agree with the value given on the nameplate of the machine. Machines designated for 230 V can also be operated with 220 V. Before use, check that: ­ The unit is filled with water ­ The tank is properly closed Connect the unit to the mains socket. During the warm-up time, some amount of hot water can run out of the steam shield. Place the steam shield in a bucket to catch the water that runs out. S Never leave the unit unattended when switched on. After about 10 seconds depending on the type of wallpaper and the background, remove the steam shield and pull or scrape off the wallpaper. During the scraping, place the steam shield again on the wallpaper. for removing wallpaper in corners or recesses , use the steam nozzle (accessory). To change the accessory, switch off the unit and pull the plug. [. . . ] Empty the unit, rinse with clear water and allow the unit to dry out. In order to avoid accidents ­ Never use the machine with a damaged cable. The wires in the cable are coloured according to the following code: Strain relief live = brown To be fitted by qualified professionals only These instructions are printed on recycled paper manufactured without chlorine. Exploded views and information on spare parts can be found under: www. [. . . ]