User manual BOSCH PVS 300 AE

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] Safety Warnings for Operation without Base Unit When working with the machine, always hold it firmly with both hands and provide for a secure stance. The power tool is guided more secure with both hands. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Apply the machine to the workpiece only when switched on and switch the machine off only after it has been lifted away from the workpiece. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is intended for dry sanding of wood, plastic and metal with high removal rates. 1 Vacuum connection 2 Thumbwheel for belt speed preselection 3 On/Off switch 4 Sanding belt 5 Adjustment knob for belt run 6 Clamping lever for sanding belt 7 Venting slots 8 Auxiliary handle* 9 Bolt hole 10 Sliding shoe 11 Guide roller 12 Tensioning roller 13 Openings 14 Base unit* 15 Stop rail 16 Quick-action clamp* 17 Guide bolt(4x) 18 Wing bolt 19 Screw 20 Stop 21 Plastic guide 22 Groove for stop 20 as parallel guide 23 Groove for stop 20 as angle guide Safety Warnings for Operation with Base Unit Connect the machine securely to the base unit and fasten it firmly against movement. Switching off the machine easily must be possible at all times. Guide the workpiece only against the switched-on machine and do not switch the machine off until after having removed the workpiece. English | 19 An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Compact Belt Sander Article number Rated power input Output power No-load belt speed Sanding belt length Sanding belt width Weight according to EPTA-Procedure 01/2003 Protection class W W m/min mm mm PVS 300 AE 0 603 327 7. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until Dec. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. Typically the A-weighted noise levels of the product are: Sound pressure level 85 dB(A); Sound power level 98 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. [. . . ] In this position, tools or knive, for example, can be sharpened without the stop. With the base unit 14 and the stop 20, trimmings/strips and profiles, as an example, can be shaped. the minimum workpiece thickness should be 5 mm. Mounting the Base Unit (see figure E1) To ensure safe handling, the base unit must be mounted to a level and firm work surface (e. [. . . ]