User manual BOSCH PWS 10-125 CE

[. . . ] Angle Grinder Order number Rated input power* Output power* No-load speed Grinding disc dia. Please observe the order number of your machine. The trade names of the individual machines may vary. * The values given are valid for nominal voltages [U] of 230/240 V. [. . . ] S Bosch is only able to ensure perfect operation of the machine if the original accessories intended for it are used. S Before any work on the machine itself, pull the mains plug. S For work with grinding or cutting discs, the protection guard 6 must be mounted. Place the protection guard 6 onto the spindle collar of the machine head as shown in the illustration. The encoding keys of the protection guard must match with the respective recesses on the spindle collar. The vibration-dampening auxiliary handle reduces the vibrations, making operation more comfortable and secure. Do not make any alterations to the auxiliary handle. Do not continue to use an auxiliary handle if it is damaged. S For all work with the machine, the auxiliary handle 3 must be mounted. Screw the auxiliary handle 3 on the right or left of the machine head depending on the working method. Press the protection guard onto the spindle collar until the collar of the protection guard faces against the flange of the machine and the encoding keys engage in the circular groove at the spindle collar. For work with the rubber sanding pad 13 or with the cup brush 16/disc brush/flap disc, mounting the hand guard 12 (accessory) is recommended. The hand guard 12 is fastened with the auxiliary handle 3. S Before any work on the machine itself, pull the mains plug. Use only grinding tools with a permissible speed at least as high as the no-load speed of the machine. Grinding and cutting discs become very hot while working; do not touch until they have cooled. s Clean the grinder spindle and all parts to be mounted. For clamping and loosening the grinding tools, lock the grinder spindle 5 with the spindle lock button 4. Actuate the spindle lock button 4 only when the grinder spindle is at a standstill!Adjust the protection guard 6 in such a manner that sparks are not emitted in the direction of the operator. Note: Encoding keys on the protection guard 6 ensure that only a protection guard that fits the machine type can be mounted. The mounting hole diameter must fit the mounting flange 8 without play. [. . . ] To lock-on, press the On/Off switch 2 down at the front until it engages. To switch off the machine, release the On/Off switch 2 or press the rear tip of it down. Perform a test run of at least 30 seconds without load. With the flap disc (accessory), curved surfaces and profiles (contour sanding) can be worked. [. . . ]