User manual BOSCH ROTAK 37 LI

[. . . ] Always check your RCD every time you use it. For products not sold in GB: B WARNING: For safety, it is essential that the mains plug 4 attached to the machine is fitted to the power supply cable 14. The couplings of connection leads must be protected against splashes and the coupling sockets on the leads must be made of rubber or coated with rubber. Fixing means for the connection leads must be used. [. . . ] Do not rapidly switch off and on. D Grassbox Starting: Fitting Lift the deflector guard 7 and hold up, fit the grassbox 6. Removing/Emptying Lift the deflector guard 7 and hold up. For non grass collection the mower can be used without the grassbox 6 in position, with the deflector guard 7 in the down position. 0 Press and hold the safety button 2. Squeeze the switch lever 1 towards handle. Release the safety button 2. the 2 1 I Stopping: Release the switch lever 1. F016 L70 483 · 06. 10 A I II 13 8 8 3 B non GB models 5 5 4 14 C 2 12 3 2 1 3 2 3 1 2 3 F016 L70 483 · 06. 10 D E 0 2 1 I 7 1 2 E 6 F G 19 18 17 15 16 F016 L70 483 · 06. 10 Mowing F Place the machine on the edge of the lawn, as close to the power point as possible. Position the cable to opposite side (already cut) at the end of each turn. When mowing do not allow the motor to labour particularly in heavy conditions. When the motor labours the speed of the motor drops and you will hear a change in the motor sound, when this occurs stop mowing, release the switch lever and raise the height of cut. Failure to do so could damage the machine. NOTE: The motor is protected by a safety cut out which is activated when the blade becomes jammed or if the motor is overloaded. When this occurs stop, remove the plug from the power supply. If these do not identify/remedy the problem, contact your service agent. Warning: Switch off and remove plug from mains before investigating fault. Symptom Machine fails to operate Possible Cause Power turned off Mains socket faulty Extension cable damaged Fuse faulty/blown Mower in long grass Motor protector has activated Safety cut out has activated Remedy Turn power on Use another socket Inspect cable, replace if damaged Replace fuse Increase height of cut and tilt mower Allow to cool and increase height of cut Allow to cool for a few minutes and increase height of cut At this time do not operate the switch lever 1 as this will prolong the reset time of the safety cut out Inspect cable, replace if damaged Contact Service Agent Allow to cool and increase height of cut Allow to cool for a few minutes and increase height of cut At this time do not operate the switch lever 1 as this will prolong the reset time of the safety cut out Increase height of cut (see "Height of Cut Adjustment") Replace blade (see "Blade Maintenance") Clean machine (see "After Mowing/ Storage") Refit blade correctly (see "Blade Maintenance") Clear obstruction Tighten blade nut/bolt Tighten blade nut/bolt Replace blade. Machine functions intermittently Extension cable damaged Machines internal wiring damaged Motor protector has activated Safety cut out has activated Machine leaves ragged finish or motor labours Height of cut too low Cutting blade blunt Underside of machine badly clogged Blade fitted upside down Cutting blade not rotating Cutting blade obstructed Blade nut/bolt loose Excessive vibration/ noise Blade nut/bolt loose Cutting blade damaged F016 L70 483 · 06. 10 Disposal Product, accessories and packaging should be sorted for environmental-friendly recycling. Only for EC countries: Do not dispose of the product into household waste!According to the European Directive 2002/96/EC on waste electrical and electronic equipment and its incorporation into national law, products that are no longer suitable for use must be separately collected and sent for recovery in an environmentally-friendly manner. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +61 (0)1 / 800 804 777 Fax . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +61 (0)1 / 800 819 520 www. bosch. com. au E-Mail: CustomerSupportSPT@au. bosch. com New Zealand Robert Bosch Limited 14-16 Constellation Drive Mairangi Bay Auckland New Zealand Australia Robert Bosch Australia Ltd. Box 66 Clayton 3168 Clayton/Victoria Service Exploded views and information on spare parts can be found under: www. bosch-pt. com Great Britain Robert Bosch Ltd. Box 98 Broadwater Park North Orbital Road Denham-Uxbridge Middlesex UB 9 5HJ Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fax Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fax Advice. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Keep bystanders a safe distance away from the machine. Switch off and remove plug from mains before adjusting, cleaning or if the cable is entangled and before leaving the lawnmower unattended for any period. Keep the supply flexible cord away from the cutting blades. Wait until all machine components have completely stopped before touching them. [. . . ]