User manual BOSCH SENSIXX B22L TDS2242

[. . . ] Thank you for buying the Sensixx B22L steam station, the new steam-ironing system from Bosch. Carefully read through the operating instructions for the appliance and safeguard them for future reference. Introduction These instructions for use contain valuable information about the unique features of this system and some hints to make ironing easier for you. We hope that you enjoy ironing with this steam station. [. . . ] Begin ironing but without pressing the steam release button. This appliance has a special function for tackling difficult creases. the "PulseSteam" function helps soften stubborn garments like jeans or linen faster. When the steam release button is activated, the steam generator will release three powerful shots of steam so that the steam reaches even deeper into the fabrics. Briefly press the steam shot button (18*) on the top of the handle. Or (model dependent) Press the steam release button (17) on the bottom of the handle two times in quick succession (double-click). Quickly pressing the steam button again. Some water drops may appear when you use the "PulseSteam" function for the first time. The water drops will disappear after you have used the function for some time. This can be used to remove creases from hanging clothes, curtains etc. Never direct the steam jet at garments that Never aim the steam at people or animals. Set the temperature control knob to at least the Hold the iron in an upright position 15 cm away From the garment being steamed. You can steam iron curtains and hanging garments (jackets , suits , coats. ) by placing the iron in a vertical position and pressing the steam release button (17-18*). energy saving button (model dependent) If the "Energy saving" button (8*) is switched on, you can save up to 25% of the energy and 40% of the water consumption (*), and still achieve good results when ironing most of your garments. It is advisable to use the normal energy setting only for thick and very wrinkled fabrics. (*) In comparison to the maximum setting. Note: If you work with the "Energy saving" function, the variable steam regulation and temperature regulation can still be used as recommended. If during ironing, the steam release button (17-18*) on the iron handle is not pressed for a certain length of time (8 minutes), the steam station will automatically switch off. The "auto shut-off" pilot lamp (9) will flash when auto shut-off has been activated. To switch the steam station back on, press the steam release button again. To extend the life of your steam generator and to prevent any build up of scale, it is essential that you rinse out the filter (4) and the boiler after several hours of use. [. . . ] Water spots are caused by steam condensation in the hose when cooling down after use. It is caused by the steam passing through the hose during steam ironing. Filter (4) located at the side of the appliance is loose. Use tap water mixed 50% with distilled or demineralised water. [. . . ]