User manual BOSCH SENSIXX DA 70

[. . . ] Com manuals search engine Downloaded from www. Com manuals search engine Index General safety instructions Description Before using your appliance for the first time Using your appliance 1. After ironing Tips to help you save energy Cleaning & Maintenance Multiple descaling system “TextileProtect” fabric protector * “StoreProtect”* Trouble shooting Guarantee conditions pag 4 7 7 7 7 8 9 10 10 11 12 12 12 13 14 14 15 17 17 18 19 B OS CH Downloaded from www. Com manuals search engine 3 EN • Operating instructions Thank you for buying the Sensixx‘x DA70 steam iron from Bosch. [. . . ] The “i-Temp” function does not apply to fabrics that cannot be ironed. Please check the garment care label for details or try ironing on a part of the fabric not visible normally. When the “i-Temp” function is selected, the blue light inside the temperature control comes on. Temperature ● ●● ●●● max i-Temp* AntiShine* Suitable for : synthetics silk – wool cotton linen any type of fabric which can be ironed dark and delicate fabrics. 1 “TempOK” indicator While the soleplate is heating up or cooling down to the selected temperature, the “TempOK” lights inside the temperature control (12) will flash. When the selected temperature is reached, the lights will stop flashing and remain lit continuously. 3 “AntiShine” function* If this function is selected, the risk of shiny marks on the garment due to the ironing is reduced. When the “AntiShine” function is selected, the blue light inside the temperature control comes on. Ironing with steam The steam regulator (3) is used to adjust the amount of steam produced when ironing. Temperature control (12) Recommended position of • eco • max the steam eco • max (3) * • regulator 1 2 3 max 1 2 3 max 1 2 3 max • eco • max • eco • max • eco • max 1 2 3 max 1 2 3 max • eco • max • eco • max 1 2 3 max 1 2 3 max 1 2 3 max 1 eco3• max max • 2 1 eco3• max • 2 • eco • max • eco • max • eco • max 1 2 3 max 1 2 3 max i-Temp AntiShine * Model dependent Downloaded from www. Com manuals search engine B OS CH 9 For better ironing results, iron the ☞☞Tip:strokes without steam to dry the last garment. Vertical steam This can be used to remove creases from hanging clothes, curtains etc. Shot of steam This can be used to remove stubborn wrinkles or to press in a sharp crease or pleat. Never direct the steam jet at garments that are being worn. Never aim the steam at people or animals. Press the shot of steam button (2) repeatedly with intervals of at least 5 seconds. Operate the iron in a vertical position at a distance of 10 cm / 4 in, and press the shot of steam button (2) repeatedly with pauses of at least 5 seconds. Ironing without steam This enables the iron to be used for dry ironing. Select an appropriate temperature for the type of material being ironed (see “Setting the temperature” section). €œSensorSecure” function The “SensorSecure” function switches off the iron when the handle is no longer gripped, thus increasing safety and saving energy. Lf the temperature is set too low, the steam is automatically switched off to avoid dripping. There may be an audible click when this occurs. [. . . ] Com manuals search engine B OS CH 15 5 Hold the iron over a sink. Press the “clean” button (10) and shake the iron until approximately one third of the water capacity of the tank is evaporated. Boiling water and steam will come out, carrying scale or deposits that might be there. 8 Then plug the iron in and heat it up again until the remaining water has evaporated. [. . . ]