User manual BOSCH SGE09A15

[. . . ] Household Appliances Internet: http://www. bosch-hausgeraete. de Bosch Info-Team: DE Tel. DTAG) 5600 054 010 (8301) en Instructions for Use en Index 4 6 7 8 9 10 11 12 Detergents . Opening and closing the door Adjusting the appliance . Selecting options/standard settings Maintenance and care . [. . . ] To delete Timer programming, reset the time to 0:00. Degree of drying If the "Degree of drying" option is selected, "Normal drying" is displayed (factory setting). Alternatively, you can select "No drying" or "Extra drying". The temperature of the final rinse is increased in all programmes for "Extra drying". (Note the higher temperature may not be suitable for fragile utensils. ) Buzzer volume You can vary the volume of the buzzer or switch it off completely. If the Buzzer volume option is selected, "Buzzer 4" is displayed (factory setting). You can select value 0 (buzzer switched off) or values from 1 (quiet) to 6 (loud). Buzzer is emitted briefly, indicating the volume which corresponds to the value just selected. Water hardness Before using the appliance for the first time or if the water hardness changes, the dishwasher softening system must be adjusted to the degree of hardness of your tap water. Proceed as described in the chapter "Adjusting the softening system". Reduce time You can reduce the running time of automatic programmes. An optimum cleaning result is still obtained as both the water and energy consumption is increased. If the Reduce time option is selected, "Reduce time: Off" (factory setting) is displayed. Return to the main menu and start the selected programme. If you do not want to use Reduce time the next time you use the dishwasher, you must switch off the option again. Rinse aid dosage You can adjust the rinse aid dosage. If the Rinse aid dosage option is selected, "Rinse aid 4" is displayed (factory setting). Do not change this setting unless there are streaks (reduced value) or water stains (increased value) on the utensils. You can select a value between 0 and 6. 21 en Language Before using the appliance for the first time, you can change the selected language (see chapter "Before using the appliance for the first time"). If the Language option is selected, several language codes are displayed. The code of the currently selected language flashes. A total of 17 codes or languages can be selected. If selecting a language code, the clear text is displayed on the lower line in the corresponding language. Standard programmes In addition to the wash programmes which can be selected from the main menu, the following standard programmes can be selected in turn from the "Normal" programme: Normal Extra ­ Normal Eco ­ Normal ­ Normal Plus. Select the desired programme and return to the main menu. If you do not want to select any of the displayed standard programmes, return to the "Standard programmes" display and then to the main menu by pressing the "Back" button . If you would like to cancel the selection of a standard programme, select the Standard programmes option. [. . . ] If the water pressure is higher, install a pressure reducing valve. Flow rate: Minimum of 10 litres per minute. Water temperature: We recommend that you use cold water. If you do use hot water, the temperature should not exceed 60 °C. Disconnecting the dishwasher Here too, it is important that tasks are carried out in the correct sequence: always unplug the appliance from the mains electricity first of all. [. . . ]