User manual BOSCH SGS 55 E 02 FF

[. . . ] 16 Switching off water softening system . 29 Save time (VarioSpeedPlus) Half load . 29 + Water softening system / , Rinse aid . 17 Switching off rinse aid refill indicator . [. . . ] You can adjust the sensitivity of the sensors in 3 stages. Standard: This setting is ideal for a mixed load and heavily soiled utensils, but also saves energy and water. 30 Operating the appliance en Sensitive: This setting adjusts the programme strength for the effective removal of food remnants, even if the amount of soiling is low. The energy and water consumption is adjusted accordingly. Very sensitive: This setting adjusts the programme strength for difficult conditions of use, for example firmly dried on food remnants. This setting is recommended if using biological or eco detergents which contain lower amounts of active agents. The energy and water consumption is adjusted accordingly. AutoPowerOff (Switching off automatically after the end of the programme) f O rewoP o t uA To save energy, the dishwasher is switched off 1 minute after the programme ends. You can also change this setting. Possible settings are: ■ off: The appliance does not switch off automatically. ■ After one minute: The appliance switches off after 1 minute. ■ After two hours: The appliance switches off after 2 hours. extraDry The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) You can switch the extraDry function on or off. Note: When ExtraDry function is switched on, Eco drying is deactivated. emotionLight (interior light) * t hg i Lno i t ome * depending on the features of your dishwasher The interior light 1" is on when the door is open irrespective of whether the ON/OFF switch ( is switched on or off. Depending on the setting of the time display, the end of programme is indicated with “Finish in” (for example 3h 25m) or “Finish at” (for example 15:20 hours). Keep pressing the setting buttons + X until the displayed time corresponds with your requirements. Press START button )", timer programming is activated. To delete the time preselection, press START button )" for approx. Switch on ON/OFF switch (. The Eco 50° programme has been preset for environmentally friendly operation whenever the appliance starts. This programme remains selected if no other programme button 0 is pressed. Note: For ecological reasons the Eco 50° programme is preset whenever the appliance starts. This conserves environmental resources and not least saves you money. The Eco 50° programme is a particularly environmentally friendly programme. According to EU regulation 1016/2010 it is the “Standard programme” which is the most efficient standard cleaning cycle for cleaning normally soiled utensils in terms of the combined energy and water consumption for cleaning these types of utensils. Programme end * The programme has ended when “Finished” is indicated on the display window at the top @ and on the front display * ):. * The end of the programme is displayed on the floor – provided the TimeLight (optical display) is switched on and is visible. [. . . ] Press and hold the Info button { 8 for 3 seconds. The chosen setting has now been stored. Warm water connection * no i t cen oc re t aw mraW * depending on the features of your dishwasher The dishwasher can be connected to cold or hot water up to max. Connection to hot water is recommended if the hot water can be supplied by energetically favourable means and from a suitable installation, e. g. solar heating system with circulation line. [. . . ]