User manual BOSCH SHE43C02WH INSTALLATION

[. . . ] These instructions are intended for use by qualified installers only. In addition to these instructions, the dishwasher shall be installed to meet all electrical and plumbing codes and ordinances (both national and local). Read these installation instructions completely and follow them carefully. They will save you time and effort and help to ensure safety and optimum dishwasher performance. [. . . ] Orient the mounting brackets as shown in Figure 10, and position the two small tabs on the mounting brackets over the two slots on the dishwasher's front corners. Push the mounting brackets down firmly to insert the tabs into the slots. Figure 10 Tip Over Hazard To avoid a tip over hazard, do not use the dishwasher until it is completely installed. When opening the door on an uninstalled dishwasher, carefully open the door while supporting the rear of the unit. Failure to follow this warning can result in serious injury. Remove the tape and pull the toe panel away from the dishwasher. Plastic Base Access Panel and Toe Panel (SHY66C, SHX99A, SHE66C, SHE99C, SHX57C, and SHV57C models only) The plastic base access panel and toe panel are in place on the dishwasher, but are not attached. Remove the toe panel first, as shown in Figure 11, then remove the plastic base access panel, as shown in Figure 11. Installing the 90° Elbow Fitting NOTE: The 90° elbow fitting is not supplied with the dishwasher, and must be purchased separately. If the dishwasher's hot water supply line is to be copper tubing, make certain the elbow has a compression fitting. Apply Teflon tape or other pipe sealant when required. Junction Box Preparation 1 Remove junction box cover (see Figure 13) by lifting the junction box cover up and off. 2 Remove the strain relief plate by removing the screw at the back of the junction box, as shown in Figure 14 and sliding the strain relief plate out. 3 Set the junction box cover, strain relief plate, and screw aside. SHU/SHE Models - Accessory Panel Installation If you have an SHU/SHE model and have ordered an accessory panel kit, install the panel prior to sliding the dishwasher into place. the panel dimensions are shown in Figure 15. SHI Models - Panel Installation SHI models come with additional mounting hardware and a template sheet with installation instructions. the stainless steel models of the SHI series also come with two extension pieces. The extension pieces are used to match the control panel height (Figure 16, "B" dimension) to the horizontal drawer line of the cabinets, and must be installed as shown in on the template sheet. The standard piece is used for drawer heights up to 6" (152mm); the long piece is used for drawer heights greater than 6" (152mm) but 6-7/16" (164mm) or less. If your drawers are taller than 6-7/16", you can either slide the extension piece in as far as it will go, or remove it and fit the door panel directly below the control panel. SHI/SHV Models - Panel Installation SHV models come with additional mounting hardware and a template sheet that will show you how to mount the panel. [. . . ] Figure 30 To Adjust the Spring Tension: 1 Obtain the provided Spring Tension Screws from the SHI/SHV Door Panel Installation Kit. 2 Insert the screws as shown in Figure 30. Turning the screw clockwise increases the spring tension. 3 Place the Cotton Insulation Strip under the unit, between the bottom of the Plastic Base Access Panel and the floor, as shown in Figure 32c. [. . . ]