User manual BOSCH SKS40E02GB INSTALLATION INSTRUCTIONS

[. . . ] 7 Switching off water softening system . 8 Switching off rinse aid refill indicator . 12 Information about comparability tests 12 Additional options . 13 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. [. . . ] The spray pressure in the lower basket is intensified, the rinsing temperature is increased slightly. Switching on the appliance ­ Turn on the tap fully. ­ Rotate programme selector 0 to the required programme. The expected programme duration flashes on the digital display @. The programme starts running. ¿ Extra drying * An increased temperature during the final rinse and an extended drying phase ensure that even plastic parts dry better. There is a slight increase in the energy consumption. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display @. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 13 en Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button H until the digital display @ jumps to : . ­ Press button H until the displayed time corresponds with your requirements. ­ Press START button 8, timer programming is activated. ­ To delete the preselected starting time, press the button H until is indicated on the digital display. You can change your programme selection at any time until the programme starts. Interrupting the programme ­ Switch off ON/OFF switch (. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. ã=Warning Never use other chlorinated household detergents!Health hazard! Special salt and rinse aid ­ Check the refill indicators ` and X. If required, refill salt and/or rinse aid. ­ Remove any residue and clean filters under running water. ­ Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system. 15 en Spray arm Limescale and dirt from the rinsing water may block nozzles and the bearing assemblies of the spray arm 1". ­ Check outlet nozzles on the spray arm for blockages. ­ Remove the spray arm upwards. Waste water pump Large food remnants in the rinsing water not retained by the filters may block the waste water pump. The rinsing water is then not pumped out and covers the filter. [. . . ] ­ Select programme with the highest temperature. The expected programme duration is indicated on the numerical display @. 4 minutes press the START button 8 until : is indicated on the digital display. 1 min is indicated on the digital display : . [. . . ]