User manual BOSCH SMI 40D06EU/19 SUPPLEMENT

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfect ly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] Using 50C dishwashing cycles in conjunction with these concentrated deter gents reduces pollution and is good for your dishes, as these dishwashing cycles are specially matched to the dirt dissolving properties of the enzymes in con centrated detergents. It is for this reason that using 50 C dishwashing cycles in conjunction with concentrated detergents can achieve the same cleaning results that can otherwise only be achieved using 65 C cycles. In daily use 17 Detergent tablets 3 Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power dur ing short cycles. Therefore please use dishwashing cycles with pre wash when using detergent tablets. Using 3in1 detergents These products are detergents with a combined cleaning, rinsing and salt func tion. 4) Test programme for Test Institutes 5) This cycle does not need any detergent. 4 16 18 17 19 9 23 25 2x Water (litres) Main wash Final rinse Drying In daily use 19 Selecting a programme When your dishes look like this, select: an intensive programme. a normal or energy saving programme. a short programme (e. g. 30 minute pro gramme). 20 In daily use Starting a dishwashing cycle Check that the spray arms can turn freely. The programme progress indicators flash. 4. Interrupting or aborting a dishwashing cycle 1 Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary. Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press and hold Start button, until the programme progress indicators flash. The dishwashing cycle has been cancelled. Ensure that the flat filter does not pro trude above the base of the washing com partment. Under no circumstances may the dishwasher be used without its filters. 23 1 24 What to do if. . . What to do if. . . Remedying small malfunctions Before you call the Customer Care Department, please check whether you cannot remedy the fault yourself with the help of the following fault ta ble or whether it is caused by faulty, electrical connections and/or faulty water con nections. In these cases the engineer must make you liable for the costs of the Customer Service intervention even during the warranty period. If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the start button. In the case of other fault messages: Cancel the dishwashing cycle. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault message. Malfunction Possible cause The tap is blocked or furred with limescale. The indicator for the end of the dishwashing cycle is flashing in rhythm 1 short light signal with approx. 3 second pause in be tween: (Problems with water inlet) Remedy Clean tap. Turn on the tap. The filter (where present) in the Clean the filter in the threaded hose fitting on the tap threaded hose fitting. Filters in the base of the wash ing compartment are blocked. [. . . ] The drain hose must be fixed to the sink outlet connection using the hose clamp supplied. Anti flood system For protection from water damage, the dishwasher is equipped with a anti flood system. In the event of a fault, the safety valve in the water inlet hose immediately in terrupts the supply of water to the appliance. Electrical connection Details about the voltage, type of supply and the fuses required are to be found on the rating plate. The rating plate is located on the right hand inner edge of the dishwasher door. To isolate the dishwasher from the mains, pull out the mains plug. [. . . ]