User manual BOSCH SMI50C02GB

[. . . ] 5HVHW  VHF    6WDUW                     en Table of contents Hygiene . Switching off automatically after the end of the programme . Protection against frost (Emptying the appliance) . 16 16 16 16 16 16 16 16 17 17 17 17 17 18 18 18 18 18 18 19 19 20 20 21 21 22 22 23 23 23 24 24 24 24 24 25 25 25 26 26 26 26 26 Safety instructions . [. . . ] – To continue the programme, switch on the ON/OFF switch ( again. Switching off automatically after the end of the programme * myftelargeodfthnpar tncmta lfaSihgouw * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Automatic disconnection can be adjusted from : to : . : : : – – – – – Appliance does not switch off automatically Off after 1 min Off after 120 min Close the door. The factory set value : is lit on the digital display H. 17 en nmgrm Tiatgheproam e Terminating the programme (Reset) – Press START button @ for approx. – The programme sequence lasts approx. On the digital display H is indicated : . – Switch off ON/OFF switch (. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine – Check spray arm for grease and limescale deposits. If you find such deposits: – Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. – Regularly clean door seal with a damp cloth. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. Changing the programme When the START button @ has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) – Close the door. – Press and hold down the START button @. – Rotate programme selector 8 until : is indicated on the digital display H. The factory-set value : is lit on the digital display H (intensive drying off). [. . . ] – A power cord extension may be purchased from customer service only. – Use only a residual current operated circuit-breaker which features the symbol ‚. Only this extension guarantees compliance with the currently valid regulations. – The appliance features a water damage protection system. [. . . ]