User manual BOSCH SMI 50E85EU/51 SUPPLEMENT

[. . . ] It is imperative that these instructions are observed. This symbol or numbered instruction steps lead you step for step through the operation of the appliance. Next to this symbol you receive additional information and practical tips on using the appliance. Tips and instructions for the economical and environmentally conscious use of the appliance are marked with a clover leaf. [. . . ] After the appliance has been closed again the air that has entered will be greatly heated and expand. As a result water may penetrate the base of the appliance and trigger the anti-flood system. Interrupting the wash programme by opening the door of the dishwasher Hot steam can escape from the appliance when the door is opened. Lights are flashing in the multidisplay. The wash programme will continue. 1 Ending the wash programme 0 1. Press the button for the wash programme that is running and hold it down until the programme indicator for the wash programme goes out. Release the programme button; the wash programme has been ended. 22 Operating Instructions Pause function 3 The pause function can only be initiated before the drying section of the programme I. If the pause function is initiated during the drying section of the programme I the wash programme is ended. Using the pause function the dishwasher can be temporarily stopped: 0 1. After a short time when the wash programme is to continue, press the ON/OFF button again. The wash programme will continue. 2 The wash programme should not be stopped for a prolonged period or the cooled water will need to be reheated resulting in increased energy consumption. Setting or changing the delay start timer Using the delay start timer you can opt to set the wash programme to start in 3, 6 or 9 hours. Remove the flat filter (3) from the base of the washing compartment and clean both faces thoroughly 3 7. Put the flat filter back in the base of the washing compartment 8. Place the coarse/fine filter in the microfilter and press together. Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. 1 Under no circumstances may the dishwasher be used without filters. 25 Operating Instructions What to do, when . . . Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call in customer service to resolve one of the malfunctions listed here, or rectify an error made in the operation of the appliance, the customer service engineer's visit is not free of charge, even during the period of guarantee. . . . Fault warnings are displayed. · If the top or middle light in the display is flashing you can probably rectify the fault yourself. Once the fault has been rectified press the ON/OFF button. If the fault is displayed again, contact your local AEG Service Force Centre. · If other lights flash in the multidisplay, please contact your local AEG Service Force Centre stating which fault indicator is flashing. Symptom: Possible Cause Solution Clean tap. Clean the filter in the threaded hose fitting. [. . . ] If the appliances are built-in, built-under, fixed or suspended in such a way that removing and replacing them in the place where they are fitted takes more than half an hour, the costs that result therefrom will be charged for. Connected damage caused by these removal and replacement operations will be the responsibility of the user. If, during the guarantee period, repairing the same defect repeatedly is not conclusive, or if the repair costs are considered disproportionate, in agreement with the consumer, the defective appliance may be replaced with another appliance of the same value. In this event, we reserve the right to ask for a financial contribution calculated according to the length of time it has been used. [. . . ]