User manual BOSCH SMI 50E86EU/51 SUPPLEMENT

[. . . ] Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information Your dishwasher has the new washing system "IMPULSE WASHING". With this dishwashing system the motor speed and spray pressure are varied during the wash cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents CONTENTS Operating instructions Safety Appliance features Control panel Prior to using for the first time Setting the water softener Adding special salt Adding rinse aid Activating/deactivating the inflow of rinse aid In daily use Loading cutlery and dishes Adjusting the height of the upper basket Adding detergent Using 3 in 1 detergent tablets Selecting the programme (Programme Table) Starting a programme Setting or changing the Start Delay Switching off the dishwasher Care and cleaning What to do when. . . [. . . ] After unloading, fold back both handle parts. UI25 UI20 Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. 13 Operating instructions The lower basket Load larger and heavily soiled dishes in the lower basket. To make it easier to load larger dishes, the rear plate rests in the lower basket can be folded down. UI12 UI92 The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates up to 24 cm in diameter), salad bowls, cups and glasses; these should be arranged as shown in the pictures. Glasses with long stems can be placed upside-down in the raised cupracks. The cup-rack on the left folds upwards to increase your loading flexibility. - low alkaline concentrated detergents with natural enzymes. The use of 50°C washing programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes; these wash programmes are specially matched to the dirtdissolving properties of the enzymes in the concentrated detergent. For this reason 50°C wash programmes in which concentrated detergents are used can achieve the same results that can otherwise only be achieved using 65°C programmes. 16 Operating instructions Detergent tablets Detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets cannot dissolve and develop their full cleaning power during short programmes. Interrupting the wash programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 1 and 2 for approx. The programme display for the current programme will flash for several seconds and then go out. If you want to start a new programme, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected programme, not cancel it. The programme will recommence after turning the dishwasher back on again. 19 Operating instructions Setting or changing the Start Delay With the delay timer you can delay the start of a programme for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi-display shows the desired time delay, for example, 12h, if the programme is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the programme is continuously displayed (e. To change the start delay: As long as the programme has not yet started, you can still change the start delay by pressing the Delay Timer button. [. . . ] ­ You must tighten the metal nut using a tool. Then do a visual check for water tightness (make sure that the tap is not dripping). · So that access to the tap in the kitchen is not limited by the use of the dishwasher, we recommend installing an additional tap, or fitting a T-branch to the existing tap. 30 Installation and connection instructions Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it to the underside of the work surface. [. . . ]