User manual BOSCH SMU53M05EU

[. . . ] Dishwasher 9000 292 316 (8712-1) en Instructions for use en Index 4 4 4 4 4 4 5 5 5 5 5 5 6 6 7 7 7 8 8 8 9 9 9 9 9 9 10 10 10 10 11 12 12 14 14 14 15 15 15 15 IntensiveZone . Remaining running time display Timer programming . Terminating the programme (Reset) Changing the programme . Overall condition of the machine Filters . [. . . ] There is a slight increase in the energy consumption. 15 en Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display 10 . The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme Switch off ON/OFF switch 1 . If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. To continue the programme, switch on the ON/OFF switch 1 again. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. display 10 jumps to Press 4 + or ­ button until the displayed time corresponds with your requirements. Press START button 6 , timer programming is activated. To delete timer programming, press the 4 + or ­ button until is indicated on the digital display. You can change your programme selection at any time until the programme starts. Terminating the programme (Reset) Press START button 6 for approx. On the digital display 10 is indicated . Switch off ON/OFF switch 1 . End of programme The programme has ended when the value is indicated on the numerical display 10 . Switching off the appliance Short time after the end of the programme: Switch off ON/OFF switch 1 . Turn off the tap (not applicable if Aqua-Stop fitted). Remove the utensils when they have cooled down. 16 en Changing the programme When the START button 6 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) Close the door. Hold down programme button A and press START button 6 until on the digital display 10 is indicated . The LED for button A flashes and the digital display displays the factory . setting Press programme button A until the is indicated on factory set value the digital display 10 . To change the setting, Press the button C to switch intensive drying on or off . [. . . ] Loosen the fastening screws under the worktop. Pull out the appliance, carefully pulling the hose behind. Protection against frost If the appliance is in a room where there is a risk of frost (e. g. holiday home), empty the appliance completely (see Transportation). Turn off the tap, disconnect supply hose and drain water. 24 en Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. [. . . ]