User manual BOSCH SPS40C12GB

[. . . ] 5HVHW  VHF       (QG K K K 6WDUW     (QG K K K               en Table of contents Half load . Protection against frost (Emptying the appliance) . 15 15 15 15 15 15 16 16 16 16 16 16 17 17 17 17 18 18 19 19 20 20 20 21 22 22 22 23 23 23 23 23 24 24 24 24 25 25 25 Safety instructions . 7 Switching off water softening system . [. . . ] – Press START button @, timer programming is activated. – To delete the preselected starting time, keep pressing the Preselected starting time button H until none of the displays 3h, 6h or 9h is lit. You can change your programme selection at any time until the programme starts. Terminating the programme (Reset) – Press START button @ for approx. – The remaining programme sequence lasts approx. Switch off ON/OFF switch (. End of programme The programme has ended when the End display )" is lit. Note To save energy, the dishwasher automatically switches off after 2 minutes after the end of the programme. Changing the programme When the START button @ has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Switching off the appliance Short time after the end of the programme: – Switch off ON/OFF switch (. – Turn off the tap (not applicable if AquaStop fitted). – Remove the utensils when they have cooled down. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. 16 en Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) – Close the door. – Press and hold down the START button @. – Rotate programme selector 8 until the “Check water supply” display h flashes. To change the setting: – By rotating the programme selector 8, you can switch on intensive drying (End display )" is lit) or switch off intensive drying (End display )" is not lit). The setting is saved. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine – Check spray arm for grease and limescale deposits. If you find such deposits: – Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. – Regularly clean door seal with a damp cloth. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. [. . . ] If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. – The connection may be modified by technicians only. – A power cord extension may be purchased from customer service only. – Use only a residual current operated circuit-breaker which features the symbol ‚. [. . . ]