User manual BOSCH SPS53M22EU

[. . . ]     K 5HVHW  VHF % K PLQ $ K 6WDUW & 5HVHW VHF                    en Table of contents Intensive zone . Switching off automatically after the end of the programme . Protection against frost (Emptying the appliance) . 16 16 16 16 16 16 16 17 17 17 17 17 17 18 18 18 18 18 19 19 20 20 21 21 21 22 22 23 23 23 24 24 24 24 24 25 25 25 26 26 26 26 26 Safety instructions . [. . . ] – Remove the utensils when they have cooled down. ã=Warning End of programme The programme has ended when the value : is indicated on the numerical display )". myftelaergdfthonpar tncmta lfaw Sihgou At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Switching off automatically after the end of the programme * * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Automatic disconnection can be adjusted from : to : . : : : – – – – Appliance does not switch off automatically Off after 1 min Off after 120 min Close the door. Hold down programme button # and press START button P until : . . . The LED for button # flashes and the digital display )" displays the factory setting : . Press programme button # until the factory set value : is indicated on the digital display )". Interrupting the programme – Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. – To continue the programme, switch on the ON/OFF switch ( again. nreTiatghpm o Terminating the programme (Reset) – Press START button P for approx. The numerical display )" indicates : . – The programme sequence lasts approx. On the digital display )" is indicated : . – Switch off ON/OFF switch (. – 17 en Changing the programme When the START button P has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) – Close the door. – Hold down programme button # and press START button P until the digital display )" : . . . The LED for button # flashes and the digital display )" displays the factory setting : . – Press programme button # until the is indicated on factory set value : the digital display )". To change the setting, – Press the button 3 to switch the Intensive drying on : or off : . The set value is saved. Overall condition of the machine – Check spray arm for grease and limescale deposits. [. . . ] – Use only a residual current operated circuit-breaker which features the symbol ‚. Only this extension guarantees compliance with the currently valid regulations. – The appliance features a water damage protection system. Please note the system will not function unless the power supply is connected. Removing the appliance Also observe the sequence of worksteps here. [. . . ]