User manual BOSCH SPS53M58EU

[. . . ] SP. . . en Table of contents Intended use . . 4 . 5 . 5 . 6 . 6 . 6 . 7 Unloading the dishwasher . 21 Express Wash/ Speed Perfect (VarioSpeed). 9 Water softening system/ Special salt . [. . . ] The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. m Warning – Health hazard Never use other domestic detergents, e. g. containing chlorine! Special salt and rinse aid Check the refill indicators h and `. If required, refill salt and/or rinse aid. 25 en Cleaning and maintenance Filters The filters 1R keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a coarse filter, a flat fine filter and a microfilter. After each washing cycle check the filters for residue. Unscrew filter cylinder as illustrated and take out filter system. Spray arms Limescale and contaminants in the rinsing water may block nozzles and bearings on the spray arms 1: and 1B. Check outlet nozzles on the spray arms for blockages. Unscrew the upper spray arms 1: (1/4 revolution). 3. Remove the lower spray arm 1B upwards. 3. Remove any residue and clean filters under running water. Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system. 4. 26 Fault, what to do? en Fault, what to do? , tF l u a w t a h o t d ?o Experience has shown that you can rectify most faults which occur in daily operation yourself. This ensures that the machine is quickly available to you again. In the following overview you can find possible causes of malfunctions and helpful information for rectifying them. Note If the appliance stops during dishwashing or does not start for no obvious reason, first run the Abort programme function (Reset). (See chapter entitled “Operating the appliance”) 3. Scoop out water, use a sponge if required. [. . . ] The factory-set value : is lit on the digital display H. By rotating the programme selector 8, you can switch the hot water setting off : or on : . The set value is saved. 38 Installation and connection en Electrical connection Connect the appliance to an alternating current only, ranging from 220 V to 240 V and 50 Hz or 60 Hz via a correctly installed socket with protective earth conductor. See rating plate for required fusing 92. [. . . ]