User manual BOSCH TAS-4302-TASSIMO

[. . . ] € This appliance is designed for prepa­ ration of small amounts of coffee for domestic use or for use in non­com­ mercial, household­like environments, such as staff kitchens in shops, ofices, agricultural and other small businesses or for use by guests at bed­and­break­ fast establishments, small hotels and similar residential facilities. € Connect and operate the appliance only in accordance with the speciica­ tions on the rating label. € Do not use your TASSIMO machine if either the power cord or appliance is damaged. € Use indoors at room temperature only and not above 2000m sea level. [. . . ] € Never attempt to open the brewing unit during the brewing process. € Keep in mind that the beverages are very hot when dispensed. € The brewing unit locks automatically when brewing beverages at a higher pressure. ► The Status LED F (3a) blinks while the machine is brewing. If you want a larger beverage, you can add more water immediately after the brewing process by pressing and hold­ ing the Start / Stop button. When the brewing process is complete, the Status LED F stops blinking. The brewing unit (4) can be opened at this point. You can sit back and enjoy it or prepare another beverage. I Note: There may be short pauses during the brewing process. This is to achieve the optimal lavour extraction. If you don’t prepare any other beverages, your machine automatically switches to power­save mode. To save even more electricity, we recom­ mend turning your TASSIMO machine off with the ON / OFF switch (1) after each use. € Switch off and unplug the appliance before cleaning. Clean your TASSIMO machine regularly to ensure that it continues to produce beverages of the best possible quality. If the appliance has been unused for a long time, run the cleaning process with the Service T DISC (6a) several times to ensure that the drinks it produces are of its normal high quality (see “First use of your TASSIMO machine”). Clean the brewing system (4) regularly with a soft, damp cloth, especially the T DISC barcode scanner (4e) and the area around the clamp, so that the T DISC barcode can be scanned properly. Wipe the outside of the appliance with a soft, damp cloth. Rinse out the water tank (5) by hand and with water only; do not place it in the dishwasher. All parts of the cup stand (7) are dishwasher­safe. Also remove the piercing unit (4c) and drink outlet (4d) by pushing them up. It is recommended to clean these parts regularly, otherwise the drink outlet could become blocked, possibly causing leakage or reduced drink sizes. – All these parts can also be cleaned in the dishwasher. [. . . ] 2012 10:51:52 en Problem Water on the surface under the cup stand. The Service T DISC is required for the cleaning cycle and the descaling cycle. 33 Solution Condensation may occur and is not a fault. Check the storage compartment for the Service T DISC behind the water tank. [. . . ]