User manual BOSCH TAS 5546CH/04 SHORT INSTRUCTIONS

[. . . ] G If you use the jug to fill the tank, 2 G G G G G G CM650 G Never let the cord hang down over the worktop edge - a child could grab it and pull the machine down. Push excess cord inside the back of the machine. Always make sure there is water in the tank before switching on. Get it checked or repaired: See `service'. [. . . ] Never put the machine in water or let the cord or plug get wet. Watch out for steam and never touch the hotplate. This machine is not intended for use by young children or infirm persons without supervision. Don't let children play with this machine. before plugging in Make sure your electricity supply is the same as the one shown on the underside of your machine. 3 4 5 G 6 G 7 CM660 G G Important (UK) only The wires in the cord are coloured as follows: Green and Yellow = Earth Blue = Neutral Brown = Live. This machine complies with European Economic Community Directive 89/336/EEC. before using for the first time Remove all packaging. Wash the parts: see `care and cleaning'. Push excess cord inside the back of the machine. Run two lots of water through the machine (without coffee) to clean it out. Press the automatic timer button and at the same time adjust the Hour and Minute buttons to display the time you want the coffee maker to come into operation. Make sure that the desired AM or PM is selected. When the set brewing time is reached the coffee maker will operate, the automatic timer light will go out and the auto/on/off light will come on. care & cleaning G G Always switch off and unplug before cleaning. Never put the machine in water or let the cord or plug get wet. jug, lid, filter holder, permanent filter Wash, then dry. body, filter door Wipe with a damp cloth, then dry. Don't use abrasives - they'll scratch the plastic. descaling You'll know when limescale has built up because your coffee will take longer to come through. When this happens it's time to descale. G G to descale 1 Buy a suitable descaler. 3 After descaling, run several lots of water through the machine to clean it out. [. . . ] When this happens it's time to descale. G G to descale 1 Buy a suitable descaler. 3 After descaling, run several lots of water through the machine to clean it out. Fill the tank to the top cup mark when you do this. 4 Wash the parts. service G If the cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer. [. . . ]