User manual BOSCH TASSIMO VIVY 2 TAS1401

[. . . ] The appliance may only be connected to a power supply with alternating current via a correctly installed socket with earthing. Ensure that the protective conductor system of the domestic supply has been correctly installed. Before cleaning the appliance, pull out the mains plug. Only use your TASSIMO appliance if the power cable and appliance show no signs of damage. [. . . ] Com to discover the large variety of beverages available and to order your discs online. The following table contains solutions to problems or faults which may occur d uring operation of the appliance and that can be easily rectified at home. If you are not satisfied with the solutions provided here, please contact our Customer Service department. Further customer service information can also be found online: www. The appliance is not The appliance has no Check to see whether the appliance is con- Working and none of the power supply. The brewing starts, however there is no The water tank is not inserted correctly. The water tank was removed during the Start the cleaning process with the yellow Service T DISC. Please refer here to the section Brewing stage or there is â First Time Use, Steps 2­14. Clean the water tank and free the float. The brewing will not The appliance does not Clean the T DISC reading window with a soft, Smooth out the foil of the T DISC with your Finger so that the bar code can be read. If the problem persists, contact the T ASSIMO careline. The brewing unit is not Clean the brewing unit with a soft, damp cloth, Paying particular attention to the lid area. The appliance was not plugged in when the T DISC was inserted. Insert a new T DISC and check that the appliance is plugged into the power supply before inserting the T DISC. The piercing unit and/ or the T DISC support have not been correctly inserted. Press the piercing unit into its holder using both thumbs and check the position of the T DISC support. The T DISC has not been Replace the damaged T DISC with a new one. Place the T DISC with the printed side facing downwards so that the tab is resting in the The brewing unit is not Clean the brewing unit with a soft, damp cloth, Paying particular attention to the lid area. Press the lid down until it audibly clicks into place. The brewing unit cannot The brewing unit is still Wait until the Status LED S has stopped blink- Ing before attempting to open the b rewing unit. If the brewing unit stays locked, contact the There is not enough Fill the tank with cold, fresh water as far as the Fill water tank R lights up even though there is enough water in the water tank. The water tank is not inserted correctly. [. . . ] During the brewing process, press the This volume can also Press and hold the Start/Stop button until the Please refer here to the In the appliance could section á Descaling. Enfoncez à l'aide des deux pouces la couronne de perçage dans son support et vérifiez la position du support T DISC. En Guarantee The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. [. . . ]