User manual BOSCH TDA7640GB

[. . . ] Solving Minor Problems Yourself Problem Possible Causes Temperature control (H) set to minimum Connection problems The automatic shut-off system has been activated (*). Solution Turn the temperature control to the desired position Check that the plug is inserted into the mains socket correctly Move the iron gently from side to side to re-start it m a x Iron does not work or is not heating up Iron is not steaming There is no water in the tank (E). Fill the water tank The steam regulator (C) is in the Set the steam regulator to the position relevant position Temperature control (H) setting is too low. Set the temperature control within the steam area (between the “••” and “max”) or turn the steam regulator (C) to Turn the steam regulator to a lower setting. [. . . ] • Do not leave the appliance exposed to weather conditions (rain, sun, frost, etc. ) • With the aim of avoiding dangerous situations, any work or repair that the appliance may need, e. g. replacing a faulty mains cable, must only be carried out by qualified personnel from an Authorised Technical Service Centre. Cleaning and Maintenance Attention !For general cleaning, follow the information below: Problem Dirty/lightly marked iron body or soleplate Mark develops on soleplate during use Heavily stained soleplate Solution Clean the body of iron or soleplate with a damp cloth then dry it. Set the iron to its maximum temperature setting. Rub the iron a few times over with a dry cotton cloth folded several times. While the iron is cold, iron a linen cloth soaked in white vinegar. Then dampen a cloth with water and wipe the soleplate clean and dry thoroughly. DO NOT de-scale or clean the water tank with cleaning products or solvents, as these could cause the iron to drip when using the steam function. DO NOT use a “professional steam cleaner” for cleaning the appliance. DO NOT use sharp objects or abrasive products to clean the soleplate or any other part of the appliance. To keep the soleplate in good condition, do not allow it to come into contact with metal objects. GUARANTEE TERMS The terms of the guarantee for this appliance are in accordance with that stated by our representative for the country in which it is sold. Details of those conditions can be obtained from the retailer from whom the appliance was purchased. The SALES RECEIPT must be presented when making any claims against the terms of this guarantee. We reserve the right to make technical modifications. Important This appliance has been designed exclusively for domestic use and must not be used for industrial purposes. Carefully read through the operating instructions for the appliance and safeguard them for future reference. Using Your Iron 1. Your iron M. Auto shut off indicator lamp* A. Setting the temperature The temperature control (H) adjusts the temperature of the soleplate (F). 1. Check the temperature instructions shown on the care label of the garment you are ironing and set the temperature control (H) to the corresponding position by lining it up with the pointer (G) on the iron: Fabric Synthetics Silk - Wool Cotton - Linen F. Ironing with steam The steam regulator (C) is used to adjust the amount of steam produced when ironing. 1. Make sure that there is water in the tank (E). 2. Adjust the temperature setting and then set the steam regulator according to the table below. Steam will automatically be produced: Temperature Setting Temperature Setting • •• ••• •• Note: At a temperature setting of “•”, the soleplate is not hot enough to produce steam so the steam regulator should be set to the position to avoid water dripping from the soleplate (F). [. . . ] Filling the water tank This can be used to remove stubborn wrinkles or to press in a sharp crease or pleat. It cannot be used on a synthetic setting for delicate items. 1. Set the temperature control (H) to the “•••” or “max” position. 2. Set the steam regulator (C) to the position. [. . . ]