User manual BOSCH TDS 222510 H

[. . . ] 13 DEUTSCH Problem Mögliche Ursachen Lösung EN • Operating instructions Thank you for buying the Sensixx B22L steam station, the new steam-ironing system from Bosch. Carefully read through the operating instructions for the appliance and safeguard them for future reference. English Open the leaflet sides You can download this manual from the local homepages of Bosch. General safety instructions ❐❐ During the use, the decalcifying or rinsing aperture of the boiler is ❐❐ The iron must not be left unattended while it is connected to the ❐❐ Remove the plug from the socket before filling the appliance with under pressure and must not be opened. [. . . ] € Sort your garments out based on their cleaning symbol labels, always starting with clothes that have to be ironed at the lowest temperatures. € If you are not sure what the garment is made of then begin ironing at a low temperature and decide on the correct temperature by ironing a small section not usually seen when worn • At the beginning of each use, it is possible that drops of water will be dispensed alongside steam. Therefore, it is advisable to try the iron on the ironing board or a piece of cloth to start with. Ironing without steam Begin ironing but without pressing the steam release button. Vertical steam  See the leaflet sides This can be used to remove creases from hanging clothes, curtains etc. : Never direct the steam jet at garments that are being worn. Never aim the steam at people or animals. Et the temperature to the “•••” setting. Old the iron in an upright position 15 cm away H from the garment being steamed. Ou can steam iron curtains and hanging Y garments (jackets, suits, coats. ) by placing the iron in a vertical position and pressing the steam release button (15 or 16*). Tips: EE “PulseSteam” function This appliance has a special function for tackling difficult creases. the “PulseSteam” function helps soften stubborn garments like jeans or linen faster. BOSCH 17 English Energy saving “eco” button (model dependent) If the “Energy saving” button (8) is switched on, you can save up to 25% of the energy and 40% of the water consumption (*), and still achieve good results when ironing most of your garments. It is advisable to use the normal energy setting only for thick and very wrinkled fabrics. (*) In comparison to the maximum setting. Note: If you work with the “Energy saving” function, the variable steam regulation and temperature regulation can still be used as recommended. Calc’n’Clean Advanced  See the leaflet sides Cleaning the Boiler To extend the life of your steam generator and to prevent any build up of scale, it is essential that you rinse out the filter (5*) and the boiler after several hours of use. If the water is hard, increase the frequency. Do not use descaling agents for rinsing out the boiler, as they could damage it. Then, rinse it again with water (very important!The descaling fluid can be obtained from our After-sales service or from our website. [. . . ] € This is a regular consequence of continued use over a long period of time. € Water is being pumped into the steam tank. € Steam release button has been activated for too long a period of time, that is, it has been pressed too frequently. • May be caused by steam condensed on the ironing board. [. . . ]