User manual BOSCH WAE32464GB

[. . . ] - Attention: Operate the washing machine with cold drinking water only. Do not connect to a mixer tap of a pressureless hot water heater. - If in doubt, have the appliance connected by a technician. Water supply 1. Take the hoses out of the holders and, depending on the model, remove the elbow. [. . . ] - Instead of the appliance cover panel, have a technician install a sheet metal cover * (* order no. WMZ 2340, WZ 10090). Useful tool - Spirit level for alignment. Installation area - Stability is important to prevent the machine from wandering!- The installation area must be firm and level. - Soft floors/floor coverings are not suitable. If installing the appliance on a base - Secure the washing machine feet with retention plates * (* order no. WMZ 2200, WX 9756). If installing the appliance on a wooden joist ceiling - If possible, install the washing machine in a corner. - Screw a water resistant wooden panel (min. - Secure the washing machine feet with retention plates * (*order no. see above). 1 2 3 4 Alignment Loud noise formation, intense vibrations and wandering" may be due to incorrect alignment! Transportation, e. g. if moving house After transporting and correctly installing and connecting the appliance, run the Drain b auxiliary programme before starting the first washing programme. Align washing machine with spirit level. 1. Loosen lock nut in a clockwise direction with a wrench. 1. Before transporting the washing machine: 2. Change height by rotating the appliance feet. All four appliance feet must be firmly on the floor. Check alignment of the washing machine with a spirit level and, if required, correct. 1. See operating instructions, page 9; Detergent solution pump. Release the water pressure in the supply hose. See operating instructions, page 9; Filter in the water supply. Isolate the washing machine from the power supply. Remove the hoses. Customer service F Before calling customer service, please check whether you can eliminate the fault yourself. See Operating instructions, page 10 «What to do if . . . ». F If you require advice, even during the warranty period, you will incur costs for the call out of a technician. [. . . ] If a residual current operated circuit breaker is used, use only a type which features this symbol: 7 Only this symbol guarantees compliance with the currently valid regulations. Do not insert/pull out the plug with damp hands. Do not pull out the mains plug by tugging the power cord. Manufacturer (see Operating instructions) 0107 / 9000 085 786 Contents J J J J J J J J J J J J Page 1 1 2 2 3 4 5 5 6 6 7 7 Technical specifications Dimensions (width x depth x height) Weight Nominal voltage Mains connection 60 x 59 x 84. 2 cm 69-83 kg depending on model 220-240 V, 50 Hz Socket (220-240 V, 50 Hz, min. [. . . ]