User manual BOSCH WAK 24160 FF

[. . . ] 85 · Preparing to install your machine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86 · Installation under a worktop . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86 · Connecting the water supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87 · Connecting to the drain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Ensure that it is tied firmly in place to avoid it coming loose during draining and causing a flood. The hose must not be twisted or kinked and must be held by the hose hook to avoid it falling to the ground (Fig. 8 Electricity supply For your safety, you must comply with the instructions below. The electrical installation must comply with Standard NF C 15-100, particularly as regards the Earthing requirements. Line 3x2. 5 mm2 single-phase 230V connected to : - A single-phase 20A 230V-50Hz meter - A differential circuit breaker and a separate fuse (10 or 16A, depending on the model) - A 2-pin + Earth 10/16A socket Advice on the electrical installation of your machine: · Do not use an extension lead, an adapter or a multiple-outlet socket. · The socket must be easily accessible but out of the reach of children. If in any doubt at all, please contact your installer. We cannot be held responsible for any accident caused by improper electrical installation. Your machine complies with European Directives EEC/73/23 (Low Voltage Directive) and EEC/89/336 (Electromagnetic Compatibility) as modified by Directive EEC/93/68. GB 88 Preparing your washing Sorting your washing Please ensure that all your items are machine-washable. Please refer to the labels on your items to select the most suitable programme . When washing a mixed load, use the programme suitable for its most fragile items. For new items, as a precaution, first of all check that they are colour-fast: see "Colour test" below. - Select an invisible area of the item Colour test - Dampen it with warm water A coloured item frequently runs when it is - Then press it on a white cloth first washed unless it is guaranteed colour· If the item does not run, you can wash fast. · Close the door by pressing it gently. · The indicator light that is lit on B constantly indicates how far your The progress light for the cycle machine's cycle has progressed. concerned on B · When the "Stop" light on B is lit, the washing cycle is complete**. The "Stop" light on B (*) - Before starting your machine, check that the power cable is connected to the socket and that the water tap is open. Also ensure that the machine's door is properly closed. (**) - When the washing cycle is complete and the "Stop" light on B is lit, you can reprogramme your machine. If you press the "Start/Pause" button 5 , the machine restarts the last cycle it has performed, including the options. - As a safety measure, once the cycle is complete, we would recommend that you unplug the power cable and then shut the water tap. GB 92 Programming Child safety: Lights and/or display · If you wish to protect your programme settings, use the "Child Safety" + The light is lit system by simultaneously holding down for at least 3 seconds the following throughout the cycle until it is buttons 3 : "Pre-wash" and "Extra Rinse" . complete It is useless to press the "Start /Pause" button again : once you have selected "Child Safety" the controls and the options are locked to avoid any erroneous operation. · To alter your programming, you must deactivate the "Child Safety" system , Proceed in the same way: simultaneously hold down for at least 3 The light goes out seconds the following buttons: "Pre-wash" 3 and "Extra Rinse" . You can deactivate the "Child Safety" system at any time. Inserting or removing an item during the cycle (impossible during spin): · Briefly press the "Start/Pause" button 5 to interrupt the cycle. · Briefly press the "Start/Pause" button 5 to restart the cycle . (*) It may take 1 or 2 minutes for the lid to unlock. If you have selected a "Delayed Start" , you can access the drum instantaneously at any time during the waiting period before the washing cycle starts without having to interrupt and restart the cycle. The "Pause" light B is lit The light B , which was lit before the pause, lights up again. Cancelling during programming, washing or a pause: · Hold down the "Start/Pause" button 5 for at least 3 seconds. You can do this at any time during the period before the cycle, during the cycle or even during a pause. [. . . ] - Remove any residue left in the filter's housing, - Clean the filter, - Replace the filter in its housing and lock it in place by turning it clockwise. - Refit the chute - Close the filter access hatch. Ensure that the filter is correctly repositioned to avoid any water leaks. Fig. 12 Cleaning the filters on the water supply The filters at the point where the water hose is connected to your machine and to the tap prevent dirt and small objects entering your machine. [. . . ]