User manual BOSCH WFF 1101

[. . . ] Washing/drying with individual settings . Installing, connecting and transporting . 4 5 6 7 12 13 19 21 25 29 35 37 39 41 42 47 52 53 54 Installation instructions 2 The new washer dryer which you have just purchased is a modern, high quality domestic appliance. Your washer dryer is distinguished by its economical consumption of energy, water and detergent. [. . . ] 600 or "---" (without final spin) is displayed. i If setting "---" (without final spin) has been selected, the washing remains in the final rinsing water. Before the laundry can be unloaded, the b Drain or B Spin programme must be performed. You can change other settings or q Press the M button. i The speed can be changed at any time by pressing the B button until the new speed is displayed. Setting "---" (without final spin) is possible until the Rinse programme section starts. 30 Start time Before a programme starts, you can specify by how many hours the start of the programme is to be delayed. q Turn the programme selector to the desired programme. q If required, press the button(s) for additional option(s). Example of Easy Care A 40 ºC programme: i The following is indicated in the display field: - programme status display, - recommended load, - maximum spin speed, - programme duration, 1:00 (1 hour). q Load the laundry and close the loading door. 1'h (h=hour) appears in the display. q Press the W button until the desired number of hours is displayed. i The start time can be set in 1 hour steps. Hold down the M button until the signal is emitted. i When the additional functions are switched on, a long signal is emitted; when the additional function is switched off, the signal is short. The volume of the signal cannot be changed. Signal for programme status The signal can be switched on and off and the volume set before the start or after the end of the programme. q Press the v button and hold down until the signal is emitted and the volume of the signal changes. q Release the button when the required volume is reached. The selected setting is stored. 34 During washing/drying Changing the programme If you have accidentally selected the wrong programme: q If the childproof lock is active, temporarily deactivate, see page 33. q Turn the programme selector to a newly selected programme. If Prewash is selected subsequently, set the programme selector to Off and reselect the programme. q If required, change the other settings, see from page 29. i The newly selected programme starts at the programme section at which the previous programme was cancelled, however with the new settings. q If required, re activate the childproof lock, see page 33. 35 Cancelling the programme If you would like to terminate a programme and remove the laundry: q If the childproof lock is active, deactivate, see page 33. [. . . ] Height difference between the placement area and drainage point: maximum 100 cm. Drainage into a siphon: q Secure connection point with 24 40 mm Ø hose clip (specialist outlet). Drainage into a wash basin: Attention The plug must not block the drain of the wash basin. q Secure the drainage hose to prevent it from slipping out of the sink. q When the water is being pumped out of the washer dryer, check that the water drains away quickly enough. 60 Aligning the washer dryer All four appliance feet must be firmly on the ground. [. . . ]