User manual BOSCH WFF 1301

[. . . ] The drying time selector / The start button . Additional functions B (Spin speed), Pre Wash" . Super Wash", Reduced Time", Higher Water Level" . Rinse Hold", Start in Hours" . [. . . ] Do not use mild deter gent or detergent for woollens as these produce excessive foam. Set the programme selector to the re quired programme, e. g. When the programme has ended, set the position. programme selector to the 16 Opening the porthole / loading the machine Opening the porthole Pull the opening handle on the porthole forwards. Loading the machine !Items which have been pretreated with sol vent based cleaning agents, e. g. stain re movers, petroleum ether, must be allowed to dry in the open before washing. foreign matter or pets are in the drum. !Before loading the machine, ensure that no 1. Place the laundry loosely and unfolded in the drum. Please observe the maximum drum loads for the different wash programmes (pages 14 and 15). Ensure that no items of laundry are jam med between the door and the rubber seal. In the case of drying programmes, locking the loading door causes the number of mi nutes of drying time remaining in the pro gramme cycle to be indicated in the "Start in Hours / Ready in Min. " display. ­ or ­ if the start time is to be delayed: Hold the Start in Hours" button down until the number of hours by which the start is to be delayed is displayed. Changing the programme see page 24. Programme sequence During washing, the lights in the programme sequence display show the programme sta tus, e. g. Rinsing. Drying programme sequence During the drying cycle the "Drying" control light in the programme sequence display illu minates. The "Start in Hours / Ready in Min. " display indicates the time remaining in the drying cycle. 20 Ending the programmes with rinse hold If you have selected the "Rinse Hold" addi tional function, the laundry is in the last rins ing water. The control light for Final Rinse in the pro gramme sequence display illuminates. The porthole cannot be opened until the laundry has been spun or the rinsing water has been pumped out. There are two ways to end the programme: The laundry is to be spun: To switch off the "Rinse Hold" function, press the "Rinse Hold" button. The water is pumped out and the laundry is spun. ­ or ­ The laundry is to be removed after pump ing: Set the programme selector to 9. The rinsing water is pumped out. 8 9 15° 30 7 4 6 Specialam. W oole progr ns 21 Programme end / switching the machine off End of programme The Anti Crease function is automatically added to the end of all Cotton / Coloureds programmes, to the Easy care programmes operating without the "Higher Water Level" additional function, and to all drying pro grammes. To prevent the formation of permanent creases in the damp, warm laundry, the load is shifted in regular intervals for up to 30 min utes after the end of a programme. The "Anti Crease" control light illuminates. [. . . ] The programme has ended, the porthole is still locked The porthole can be opened: - when the "End" light is off. - No drying programme has been selected. - No drying programme or too short a drying programme was selected. - Suds pump is blocked. Foam is visible after last rinse Motor noise Pump noise Vibrations when washing and spinning The laundry has not been spun Extended programme time Porthole cannot be opened. [. . . ]