User manual BOSCH WFT2806GB

[. . . ] Logixx Wash and Dry GB Instruction Manual and Installation Instructions Internet: http://www. bosch-hausgeraete. de Contents Important information Notes on disposal Page 3 3 3 4 5 6 7 8 9 10 11 12 14 14 14 15 16 17 18 20 21 22 23 23 23 24 24 24 24 25 25 25 25 25 26 27 28 29 32 33 Packaging of new appliance . . Your new washer / dryer Environmental protection / notes on saving . The programme selector / the programmes . [. . . ] Ensure that no items of laundry are jam med between the door and the rubber seal. Close the porthole by pressing it shut until it engages audibly. Measuring and filling detergent see pages 11 and 13. Opening the water tap The water tap must remain open also during the drying cycle because cooling water is required. 17 Setting a wash programme Your washer/dryer provides you with three washing modes: Washing only Drying only Continuous washing and drying cycle Setting a wash programme Set the programme selector to the required programme, e. g. You can select additional functions to cope with special situations. The drying time selector must be set to the 0 position. continue with "Start", page 20. Setting the drying time programme Set the programme selector to the desired programme, e. g. To re mind you that a drying time must still be set, the "Drying time" control light flashes. Set the drying time selector to the desired drying time. continue with "Start", page 20. 123 4 5 Recommended drying times (minutes): Degree of dryness closet dry iron damp 2, 5 kg Cottons/ coloureds 2 kg Easy care 2 kg Acrylics 75 70 65 60 45 45 Set shorter drying times for smaller laundry loads. To prevent overdrying of laundry which would cause it to shrink or crinkle, avoid se lecting excessively long drying times. In addi tion, overdrying would consume energy un necessarily. Note: Warm laundry appears more damp to the touch than cold laundry. This can easily lead to misjudgements. 18 Setting a wash programme Selecting a continuous washing / drying programme 1. When washing cottons/coloureds, use ma ximum loads of 2. 5 kg. Set the programme selector to the desired programme, e. g. Select additional functions as required. 4. Set the drying time selector to the desired drying time. Setting a drying time automatically adds a drying programme to the active wash and spin programme, taking into account the type of laundry being washed. At the start of the drying cycle, the "Start in Hours / Ready in Min. " display indicates the number of minutes of drying time remaining in the programme cycle. To protect the laundry in the case of wool pro grammes, erroneously selecting a drying time will not cause a drying cycle to be added to the wash programme. When washing temperature sensitive fabrics: Press the "Higher Water Level" button. This causes the drying temperature to be lowered in the Easy care programme (dry ing of acrylics), and the Anti-Crease func tion to be switched off. Tip: a summary of programmes and addi tional buttons can be found in the slot in the soap dispenser. 19 Starting a programme / Programme sequence Approximately two seconds after selecting the programme, the unit is ready to start. If the door is not shut properly a safety device prevents the machine from operating. Press the "Start" button. [. . . ] The "Anti-Crease" light is on. The "End" light is on Porthole cannot be opened. The "End" light is flashing The dryer does not function 30 Rectifying minor malfunctions yourself If a control light is flashing in the programme sequence indicator on the operating panel, or a light is illuminated and a number appears in the Start in Hours / Ready in Min. " display, this is an indication of either a deviation from the normal programme sequence or an operational mal function. If you notice one of the displays listed in the following, you can rectify the malfunction yourself. Display Control lights in the programme sequence display Pre Wash Drying Number in the Start time dis play 15 Possible causes / P ibl Remedial action ­ Porthole not closed. [. . . ]